Kicker ZX2500.1, ZX1500.1, ZX1000.1 manual Troubleshooting

Page 6

TROUBLESHOOTING

If your amplifi er does not appear to be working, check the obvious things fi rst such as blown fuses, poor or incorrect wiring connections, incorrect setting of crossover switch and gain controls, etc. There is an illuminated red badge on top of the amplifi er denoting the power state of the amp in addition to the Protection LED on the end panel of your KICKER ZX series amplifi er. When the red badge is lit, this indicates the amplifi er is turned on and the amplifi er is functioning properly.

RED Badge Light off, no output? With a Volt Ohm Meter (VOM) check the following: +12 volt power terminal (should read +12V to +16V) Remote turn-on terminal (should read +12V to +16V) Check for reversed power and ground connections. Ground terminal, for proper conductivity. Check for blown fuses.

RED Badge Light on, no output? Check the following: RCA connections Test speaker outputs with a “known” good speaker. Substitute source unit with a “known” good source unit. Check for a signal in the RCA cable feeding the amplifi er with the VOM meter set to measure “AC” voltage.

Protection LED flashing with loud music? The red LED indicates low battery voltage. Check all the connections in your vehicle’s charging system. It may be necessary to replace or charge your vehicle’s battery or replace your vehicle’s alternator.

Protection LED on, no output? Amplifi er is very hot = thermal protection is engaged. Test for proper impedance at the speaker terminals with a VOM meter (see the diagrams in this manual for minimum recommended impedance and multiple speaker wiring suggestions). Also check for adequate airfl ow around the amplifi er. Amplifi er shuts down only while vehicle is running = voltage protection circuitry is engaged. Voltage to the amplifi er is not within the 10–16 volt operating range. Have the vehicle’s charging and electrical system inspected. Amplifi er will only play at low volume levels = short circuit protection is engaged. Check for speaker wires shorted to each other or to the vehicle chassis. Check for damaged speakers or speaker(s) operating below the minimum recommended impedance.

No or low output? Check the balance control on source unit Check the RCA (or speaker input) and speaker output connections.

Alternator noise-whining sound with engine’s RPM? Check for damaged RCA (or speaker input) cable Check the routing of RCA (or speaker input) cable Check the source unit for proper grounding Check the gain settings and turn them down if they are set too high.

Reduced bass response? Reverse a speaker connection from positive to negative on the stereo/subwoofer channel(s); if the bass improves, the speaker was out of phase.

Ground Noise? KICKER amplifi ers are engineered to be fully compatible with all manufacturers’ head units. Some head units may require additional grounding to prevent noise from entering the audio signal. If you are experiencing this problem with your head unit, in most cases running a ground wire from the RCA outputs on the head unit to the chassis will remedy this issue.

Please Note: Modern high performance speakers have a lower DC Resistance than what used to be available. The KICKER Coaxial and Component speakers are rated at four ohms (some DC Resistances may be as low as 3 ohms) and work with any amplifi er designed to operate at a four ohm load. If you want to use two KICKER Coaxial or Component speakers on a single channel of your amplifi er, wire the speakers in series. This will improve the sound quality, lower the total harmonic distortion and lessen the thermal load at the amplifi er. This may prevent an amplifi er from shutting down due to over-current protection circuitry.

CAUTION: When jump starting the vehicle, be sure that connections made with jumper cables are correct. Improper connections can result in blown amplifi er fuses as well as the failure of other critical systems in the vehicle.

If you have more questions about the installation or operation of your new KICKER product, see the Authorized KICKER Dealer where you made your purchase. For more advice on installation, click on the SUPPORT tab on the KICKER homepage, www.kicker.com. Choose the TECHNICAL SUPPORT tab, choose the subject you are interested in, and then download or view the corresponding information. Please E-mail support@kicker.com or call Technical Services (405) 624-8583 for unanswered or specifi c questions.

6

ZX AMPLIFIERS

2010 ZX 1000.1 1500.1 2500.1 RevD.indd 6

10/15/2009 11:05:22 AM

Page 5 Page 7
Image 6
Page 5 Page 7
Contents ZX Amplifier ZX1000.1 / ZX1500.1 / ZX2500.1 InstallationModel Performance≤24 Model External Fuse Power/Ground Wire Kicker Wiring KitSold separately ≤18Mono Operation OperationMinimum impedance of 2 ohms Zxrc Remote Bass Installation Troubleshooting A. Only EE.UU. solamente Nur USA Les USA Seulement ZX1000.1 ZX1500.1ZX2500.1 Rendimiento Amplificador DE LA Serie ZX.1Modelos InstalaciónNo incluido KickerConexión a tierra o blindaje 45cmFuncionamiento Monofónico FuncionamientoImpedancia mínima de 2 ohmios Zxrc Control Remoto DE Bajos Instalación Soporte de MetalResolución DE Problemas ZX1000.1 Modell Verstärker DER ZX.1 SerieBenutzerhandbuch LeistungOder Modell Externe Sicherung Massekabel Kicker VerkabelungssatzNicht inbegriffen MONO-BETRIEB BetriebMinimalimpedanz von 2 Ohm Zxrc BASSPEGEL- Fernbedienung Installation Problembehebung ZX1000.1 Performances Amplificateur Série ZX.1 Manuel d’utilisationModèle Modèle ZX1000.1 ZX1500.1 ZX2500.1Non inclus Modèle Fusible Fil de Masse Externe AlimentationKicker Kit de câblage ≤18 45cmFonctionnement Mono UtilisationImpédance minimum de 2 ohms Zxrc Télécommande DU Niveau DES Graves Installation MétalliqueEN CAS DE Difficulté ZX1000.1 Electronics Limited Warranty What to do if YOU Need Warranty or ServiceInternational Warranty Garantía InternacionalStillwater Designs
Related manuals
Manual 10 pages 39.35 Kb

ZX1000.1, ZX1500.1, ZX2500.1 specifications

Kicker, a renowned name in car audio, is celebrated for its high-performance amplifiers, including the ZX series: ZX1000.1, ZX2500.1, and ZX1500.1. Each model in this line is engineered to deliver exceptional power and clarity, making them ideal for audiophiles and casual listeners alike.

The Kicker ZX1000.1 is a compact yet powerful monoblock amplifier, capable of delivering 1000 watts RMS at 2 ohms. It features a Class D topology, which ensures high efficiency while minimizing heat generation. This means that even during prolonged use, the ZX1000.1 maintains performance without overheating. Its adjustable low-pass filter allows users to tailor the output to their specific subwoofer needs, ensuring optimal sound reproduction. Additionally, the amplifier’s variable bass boost enhances lower frequencies, providing that deep, punchy bass that enhances any audio experience.

Moving up the line, the Kicker ZX1500.1 offers even more power, delivering a robust 1500 watts RMS at 2 ohms. This amplifier is engineered with advanced thermal management technology, which helps maintain performance stability under demanding conditions. Like its smaller counterpart, the ZX1500.1 includes a low-pass filter, bass boost, and a convenient remote control option that allows users to adjust the bass output from the driver’s seat. This extra control is essential for tuning the system according to personal preference and listening environment.

For those seeking even greater power, the Kicker ZX2500.1 is a powerhouse, producing an impressive 2500 watts RMS at 2 ohms. Designed for serious audio enthusiasts, this amplifier is built to handle the most demanding subwoofers without compromise. It includes the same user-friendly features found in the ZX1000.1 and ZX1500.1, such as the adjustable low-pass filter and bass boost. Additionally, the ZX2500.1 is equipped with a rugged chassis, ensuring durability and protection for the internal components.

All three models in the Kicker ZX series boast an easy-to-navigate control panel, allowing for simple installation and adjustment. With a sleek design and high-quality construction, these amplifiers not only sound great but also look fantastic in any vehicle. The Kicker ZX amplifiers are an excellent choice for anyone aiming to elevate their audio experience with power, clarity, and functionality. Whether you choose the ZX1000.1, ZX1500.1, or ZX2500.1, you're guaranteed an exceptional investment in your car's audio system.
Top Page Image Contents