Bissell 33N7 Emptying the dirt cup, Cleaning the pre-motor filter, Washable Pre Motor Filter

Page 9

Maintenance and care

2.

 

Emptying the dirt cup

1.Turn vacuum OFF ( ) unplug the vacuum from electrical outlet.

2.Open the dirt cup compartment by lifting up the door latch on the front of the vacuum.

3.Lift the dirt cup assembly out from the vacuum.

4.Remove the top cover from the dirt cup assembly by unfastening the latch, raising the front edge and removing the top cover from the rear hinges. Set the top cover aside.

5.Empty the dirt into a garbage container.

6.To reattach the top cover on the dirt cup, align the slots on the top cover with the hinges on the dirt cup and rotate the front cover down to the closed position. Then fasten the latch.

7.Place the dirt cup back into the vacuum.

8.Close dirt cup compartment door and press down gently until it locks into place.

NOTE: The compartment door will not close without the dirt cup in place.

Cleaning the pre-motor filter

The pre-motor filter protects the motor from dirt and dust particles.

1.Turn vacuum OFF ( ) unplug the vacuum from electrical outlet.

2.Open the dirt cup compartment by lifting up the door latch on the front of the vacuum.

3.Remove the filter frame from the filter holder by grasping the lip of the frame and pulling up.

4a.4b.

6.

WARNING: To reduce

the risk of electric shock, turn power switch OFF and disconnect plug from electrical outlet before performing maintenance or trouble- shooting checks.

NOTICE:

This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

Washable Pre-

Motor Filter

3.

4.Remove the filter from the filter frame and clean by hand washing in warm water. A mild detergent can be used if desired. Allow the filter to air dry completely before replacing.

5.Place the filter back into the filter frame and replace back into the filter holder.

NOTE: The filter frame should be placed so the protective frame is visible.

6.Replace the dirt cup back into the dirt cup compartment.

7.Close dirt cup compartment door and press down gently until it locks into place.

w w w . b i s s e l l . c o m

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

Tip:

For maximum cleaning performance, check the filters often and clean or replace if necessary.

169

Image 9
Contents Pet Hair Eraser W w . b i s s e l l . c o If your appliance is fitted with a nonrewireable BS Do not handle unit with wet handsThis model is for Household use only Handle Air Flow Regulator Flex Hose CarryPost-Motor Hepa Button Media Filter Dusting Brush AttachmentOnce assembled, you can store your TightenVacuum in one of two positions Storing in the in-use position Power cord Power button Power Button Automatic cord rewindSpecial tools Pet Hair Eraser Floor NozzleUse the crevice tool in tight, narrow spaces Variable suction power control Clean filter indicatorAir flow regulator Emptying the dirt cup Cleaning the pre-motor filterTurn vacuum OFF unplug the vacuum from electrical outlet Washable Pre Motor FilterReplace the post-motor Hepa media filter with a new filter Replacing the post-motor Hepa media filterCyclone Chamber Opening Clearing clogs from the dirt cupMaintaining the Wide Pet TurboBrush Filters are dirty Dirt cup is full Check electrical plug Press power button downCrack or hole in flex hose Wraped around brushAm 5 pm Am 4 pmMonday Thursday 203-7257 203-7289 Dirt Cup Assembly 203-7259203-7256 203-7265 Upholstery Brush 203-7266Monday Thursday Warranty Bissell Pet Hair Eraser Cyclonic bagless canisterAm 5 pm Am 4 pm