Troubleshooting
Vacuum cleaner won’t run
Possible causes
1.Vacuum cleaner is not plugged in
2.Power button is not pressed down
WARNING:
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet before performing maintenance or troubleshooting.
Remedies
1.Check electrical plug
2.Press power button down
Vacuum cleaner won’t pick up or low suction
Possible causes | Remedies |
1.Tools, flex hose and/or telescoping extension wand are blocked
2.Filters are dirty
3.Dirt cup is full
4.Swivel hose not securely attached to suction opening
5.Crack or hole in flex hose
6.Air flow regulator or variable suction power control is set to open or minimum setting
1.Remove each part and check for blockages
2.Check and clean or replace all filters
3.Empty dirt cup
4.Make sure swivel hose is locked into suction opening
5.Check hose and replace if needed
6.Change to closed or maximum setting
7. Wide Pet TurboBrush is clogged or debris is | 7. Check Wide Pet TurboBrush, see page 12 |
wraped around brush |
|
Visible dust escaping from vacuum
Possible causes | Remedies | ||
1. | Dirt cup is full | 1. | Empty dirt cup |
2. | Filters missing or installed incorrectly | 2. | Check all filters for correct installation |
3. | Filters are dirty | 3. | Check and clean or replace all filters |
4. | Flex hose is blocked | 4. | Remove hose and check for |
|
|
| blockages |
5. | Swivel hose not securely attached to suction opening | 5. | Make sure swivel hose is locked into |
|
|
| suction opening |
6. | Crack or hole in flex hose | 6. | Check hose and replace if needed |
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
w w w . b i s s e l l . c o m
136