• Assists in cleaning the rake in case it's needed (N). |
N |
• Aids in the removal of small waste particles (P).
11. Install paw cleaning ramp:
• The |
on the sides of the waste receptacle compartment cover. |
P | • Position the |
| |
| • Insert the pivot pins into the holes (Q). |
| • Tug slightly on the ramp to ensure that it is firmly in place. |
Q |
|
| Install rake |
| 12. Align tracks on back of rake (each end) and slide into |
| grooves on motor housing (R). |
R |
|
| 13. Remove the AC adapter from where it is packed in the |
| styrofoam and plug it into the unit (S). |
• Plug the cord into a standard electrical wall outlet.
| • Press the ON/OFF button to turn unit ON. The rake will | |
| automatically run through its first cleaning cycle and smooth | |
S | ||
out the litter. | ||
|
Important: When the On/Off button is in the Off position it only disables the rake function.
14. Place the 4 tent plugs into the 4 holes on top housing.
Note: Always use both hands to move LitterMaid® litter box by holding handle cutouts located on each side of the tray.
OPTIONAL PROGRAMMABLE TIME FUNCTION: The timer function allows you to deactivate the unit for up to 9 hours at your convenience. Once the time is up, it will restart again and run one cycle. To program the timer, you must first set the clock.
Setting the clock
1.Set the clock to the time of day by pressing the hour then minute button.
9
Note: If setting P.M., be sure light in the upper left corner of the display is lit. The LED continues to blink 12:00 until the clock is set.
Programming the Timer
Sleep mode deactivates the cleaning cycle for a period of 9 hours. During this time the ionic air cleaner automatically turns on for 10 minutes every hour to freshen the air.
After 9 hours the unit will perform one litter raking cycle and then resume normal operation. The
To Program the Sleep Mode Timer (T)
1. Set the clock to the time of day by pressing the hour then minute button.
| Note: If setting P.M., be sure light in the upper left corner of | |
T | the display is lit. The LED continues to blink 12:00 until the | |
clock is set. | ||
|
2.Press the SET button on the control panel to begin programming.
3.Sleep mode red LED starts blinking.
4.Press the HOUR and MINUTE button (light indicating P.M. is in the upper left corner of the LED display) to set the time you want the sleep mode to begin (for example, if you set the time for 10:00 P.M. the unit remains in the sleep mode until 7:00 A.M. (9 hours).
5.Sleep mode time is automatically accepted if no buttons are pressed for 3 seconds or more.
6.Sleep mode red LED stops blinking and red LED is not lit.
7.Sleep mode is now set but is not activated.
To Activate Sleep Mode
1.Press and hold the set button.
2.Steady red light comes on to indicate that the sleep mode is activated.
To Deactivate Sleep Mode
1.Sleep mode must be activated (red LED lit) to be deactivated.
2.Press the SET button, steady red LED is no longer lit.
Ionic Air Cleaner
•As soon as the cat leaves the litter box, the sensor activates the
•The ionic air cleaner stays on during the countdown and the cleaning cycle.
•If the sleep timer is activated the rake will not cycle for 9 hours from the set sleep mode time but the ionic air cleaner will automatically turn on every hour for 10 minutes.
Optional Items:
For more information, call
10