Honeywell 3-48C, 3-520C, 3-144C manual Modify Type, UserAccess Levels Duress Code

PIN + ent

0 = OMIT ZONES [ent] to Select

8

8 = CODES [ent] to Select

ent

CODES

1 = User Codes

ent

001 USER

L3

ent

[ent] to Select 1 = Modify PIN

>A

[ent] to Select

2 = Modify Level

ent

001 Level

>_3

ent

Modify Type

Each user is assigned an access type which determines the menu options available to the user (see Table 1. Menu Options). On selecting this option, enter the type to be assigned to the user and press the ent key to accept the programming and return to the previous menu level. See Table 3. User Access Levels, for access availability.

EN50131-1		Type	Access Availability
Level
1	1.0†	Guard	Entered into event memory – no other option
2	2.1†	Cleaner	Can only set the system
2	2.2†	Caretaker	Can only set and unset the system
2	2.3	Users	Menu options 11 - 19
2	2.4	Users	Menu options 11 - 29
2	2.5	Users	Menu options 11 - 39
2	3.6‡	Manager	Menu options 11 - 49
3	3.7‡	Engineer	Menu options 11 - 71
3	3.8‡	Remote	Menu options 11 - 71
	†	No access to menu functions

‡ The manager, engineer and remote codes (the last three codes on the system) have fixed types which cannot be reprogrammed.

Table 3. UserAccess Levels

• Duress Code

If the # key is pressed while Modify Level is accessed, then the current code is assigned as a Duress Code. There is no limit to the number of codes which can be assigned as Duress. Entering a duress code at any time activates outputs programmed as Duress or PA.

Any valid PIN followed by # # ent (the ent key can be replaced by either the A> or <B key) can be used as a Duress Code. This is disabled in the UK to comply with regulations.

19