Installation
Wiring
Signal is input into the amplifier using the low level RCA input connections. If your source unit does not have RCA output connectors you will need to use a
The output (PAST) RCA jacks provide an unaltered signal
The ground should be connected to the amplifier first before making any of the other connections. This wire should be as short as possible (24 inches or less) and connected to a paint/corrosion free solid metal area of the car’s chassis. Use the same gauge wire as recommended for the amplifier’s power connection to the battery. Adding an additional ground wire between the car battery’s negative post and the car chas- sis of this same gauge (or larger) is also recommended.
System Diagrams
TWO CHANNEL OPERATION (STEREO)
SX.2 series amplifiers are capable of operating into a minimum impedance of 2 ohms per channel in stereo operation.
GROUND | SIGNAL IN | RIGHT SPEAKER(S) |
| SIGNAL OUT |
|
Installation
output to feed another amplifier or component.
SOURCE UNIT
If you ever need to remove the amp from the vehicle after it has been installed, the ground wire should be the last wire disconnected from the amplifier, just the opposite of when you installed it.
A fuse must be installed within 18 inches of the battery to protect the power wire feeding your amplifier. This fuse should be of at least the same value used in the amplifier but no higher than the capacity of the power wire. See the charts below for wire size and fusing recommendations.
REMOTE |
|
| |
18" |
|
or less |
|
+12V | FUSE |
BATTERY |
|
_
+
R-
* | kicker * |
|
| ||
|
|
|
| R+ |
|
|
|
|
| L- |
|
M1 | M2 | M3 | M4 |
| _ |
ESC | HOME | ENT | L+ |
+
Model | Fuse Size | Wire Size |
SX400.2 | 50A | 4 GA |
SX500.2 | 60A | 4 GA |
SX600.2 | 80A | 4 GA |
SX900.2 | 120A | 2 GA |
LEFT SPEAKER(S)
BRIDGED OPERATION (MONO)
SX.2 series amplifiers are capable of operating into a minimum impedance of 4 ohms when in bridged operation.
The use of twisted pair interconnects is recommended for all installations to minimize noise. When routing these cables through the automobile, try to keep them away from factory wiring harnesses and other power wiring. If you need to cross any of this wiring do so at a 90 degree angle to reduce the possibility for noise problems.
When working with power connections it is always recom- mended that you disconnect the battery to prevent accidents.
| Wire Size | Length | Maximum Fuse | |
| 8 Ga | Less than | 70 Amps | |
| 4Ga | 175 Amps | ||
| 10 feet in | |||
| 2 Ga | 250 Amps | ||
| length | |||
| 0Ga | 400 Amps | ||
|
| |||
| 8 Ga | 10 feet to | 40 Amps |
|
| 4 Ga | 90 Amps | ||
| 20 feet in | |||
| 2 Ga | 150 Amps | ||
| length | |||
| 0 Ga | 200 Amps | ||
|
|
GROUND
REMOTE |
|
| |
18" |
|
or less |
|
+12V | FUSE |
BATTERY |
|
* kicker *
M1 M2 M3 M4
ESC HOME ENT
SIGNAL IN
SIGNAL OUT
R-
L+
MONO SPEAKER(S)
_
+
8 | SX .2 Series Amplifiers |
SX .2 Series Amplifiers
9