STEREO AND MONO SIMULTANEOUSLY (SAMS)
SX.2 series amplifiers are capable of operating into a minimum impedance of 4 ohms mono and 2 ohms stereo simultaneously with the use of passive crossovers.
USING THE SIGNAL OUTPUT JACKS (PAST)
The Output (Pre Amp Signal Transfer) RCA jacks allow you to send the incoming signal from one Kicker SX series amplifier to another amplifier or processor without the need for Y
SOURCE UNIT
Installation
GROUND
REMOTE |
|
| |
18" |
|
or less |
|
+12V | FUSE |
BATTERY |
|
R-
* kicker *
R+
L-
M1 M2 M3 M4
ESC | HOME ENT | L+ |
SIGNAL IN
SIGNAL OUT
RIGHT SPEAKER(S)
_
_
HIGH PASS
CROSSOVER +
_ | + |
| MONO | |
| ||||
HIGH PASS | + |
| SPEAKER | |
CROSSOVER | LOW |
| ||
|
| |||
|
| PASS |
|
CROSS-
cables. The signal from the PAST jacks is identical to the signal fed to the amplifier via its RCA input jacks and is not affected by any of the amplifier’s
Most head units with high voltage outputs should be capa- ble of driving up to ten amplifiers in a chain.
Installation
LEFT SPEAKER(S)
OVER
These are just a few of the many ways you can use your SX.2 series Kicker amplifier. These system diagrams are designed to give you a basic understanding of the most com- mon uses for this amplifier. For more complex systems please visit your local authorized Kicker dealer. You can also download the SX Technical Manual from our website at www.kicker.com for more detailed information and complex system diagrams.
To Next Amplifier or Processor
10 | SX .2 Series Amplifiers | SX .2 Series Amplifiers | 11 |