White Rodgers SST1600, SST2000, SST1400 owner manual Typical Mounting Positions, Counterflow

TYPICAL MOUNTING POSITIONS

Air Flow

Air Flow

Air Flow

Rear View Rear View

Figure 6	Figure 8
	Figure 7

BASEMENT FURNACE (LOWBOY) (Figure 6)

Cleaner is mounted hori- zontally in return plenum, just above furnace.

COUNTERFLOW

FURNACE (Figure 7)

Cleaner is mounted horizon- tally in return duct or plenum, just above furnace.

HIGHBOY FURNACE (Figure 9)

Installation beneath furnace. Cleaner mounts horizontally, where return air enters from below. Raise furnace and in- stall beneath base.

HIGHBOY FURNACE (Figure 8)

Side installation. Cleaner is mounted vertically, where return air enters side inlet of furnace.

Less than
7 Inches	Offset

At Least

9 Inches

	Air Flow
	Figure 10
	OFFSET INSTALLATION
Figure 9	(Figure 10)
	Typical use of duct offset to match air filter opening.
	If duct connection to furnace allows less than nine
	inches for mounting the air cleaner, shorten the
	lateral trunk, or attach an offset fitting to the elbow.

Air Flow

HORIZONTAL FURNACE (Figure 11)

Cleaner is mounted vertically in the return duct near furnace.

Figure 11

5