Whirlpool ACE184XM0 manual Type 1 1 Type

11l Drill holes in the cabinet and attach it securely to finish frame. Use ten ~10 x 1” wood screws (four screws for each side and two

screws for the top; not included). Do not

overtighten screws or cabinet will distort and provide a poor air seal between cabinet and unit.

12l Insert plastic drain-cup spout and metal holder (on certain models) into hole at rear of cabinet, as shown in Figure 8. Spout shou!d be facing

downward through hole. OPTIONAL: During

high humidity, condensate may drip from

the outside of your air conditioner onto the

ground below. If your air conditioner is

installed where this is undesirable, you can direct the water to a more suitable spot by

simply attaching a 51’8” inside-diameter, thin walled hose to the drain spout at rear of

cabinet (see Figure 9). On models without plastic drain cup spout, use flashing as needed to guide water.

Note the type of drain parts you have. Insert drain cup according to instructions in Figure 8.

Figure 8

PLACE PLASTIC

DRAIN INTO HOLE

IN REAR OF

CABINET WITH

SPOUT DOWN

-PLACE DRAIN CUP

INTO METALI I BRACKET AND

INSERT INTO

CABINET RAIL SLOTS

TYPE 1 1 TYPE 2

Figure 9

13. If you received one adhesive-backed seal strip

(l/4” x l/2”), remove paper backing from

seal and install on air conditioner as shown in Figure 10.

14l Insert air conditioner into cabinet. Do not push against sharp fins and plastic parts.

Attach green ground wire to the left-front corner of unit base by using retainer screw (see Figure 11).

Figure 11

SCREW I GROUND WIRE

Figure 12

BOTTOM WEATHER

SEAL -PRESS UPWARD

(Adhesive side on bottom of base )

15. For installation of bottom weather seal on unit

with 18 3/4”-high cabinet, see Figure 12.

16. Attach front, by placing bottom edge on clips and pushing top down, then in and up.

17. Caulk all outside wall openings around cabinet.

18. If needed, install molding around room side of cabinet.

Y