3. Loft up and away from the bottom sprrng cltps | 2. Clean filter, using a vacuum cleaner. |
3. If very drrty, wash filter with warm water and mild
detergent. Air dry thoroughly before replacing.
4. Replace elastic band.
4.Remove and clean filter. (Follow instructions under
“Cleaning Air Conditioner Filter.“)
5.Clean front panel using a soft cloth with warm water and mild soap or detergent. Rinse and dry.
6.Wipe control panel clean with a soft dry cloth
7.Replace front panel.
Annual Maintenance for Your Air Conditioner
Your air conditioner needs annual maintenance to help
insure steady, top performance throughout the year.
Call the service company recommended by your dealer to:
l Inspect and clean the coils and condensate water passages.
l Check fan and oil the fan motor.
(The compressor IS sealed and needs no oiling.)
Expense of annual inspection IS customer’s responsibility.
Do not use cleaning fluids, solvents, abrasive |
| Maintenance |
| ||||||||
|
|
|
|
|
|
|
| ||||
cleaners, | or | strong detergents. They may |
| If | you | are familiar | with electrical | appliances | you can | ||
damage | the | parts. | I | ||||||||
do | the | cleaning | and | maintenance | yourself. If you decide | ||||||
I |
|
|
| ||||||||
|
|
|
| to | go | ahead, | follow | these steps. |
|
| |
Cleaning Air Conditioner Filter
The filter IS cleanable. A clean filter helps remove dust, lint and other particles from the air. Check every two weeks to see if filter needs cleanrng.
1.Remove front panel from unit. (Follow instructions under “Cleaning of Front Panel”.) Remove filter from plastic front frame. by removing elastrc band which holds It tn place.
Electrical Shock Hazard Disconnect power cord from receptacle before performing any maintenance. Be sure no liquid gets into the motor, electrical control box or com- pressor electrical terminals. Failure to follow the above precautions could result in personal injury.
1.Remove unit from window
2.Remove front panel. (See page 4)
3.Remove side curtains. Slide curtains out to fullest width. From the back side, remove the phillips head screws (A) which attach the curtains to the cabinet.
4.Remove slotted/hex head screws (B) holdrng top channel.
5.Remove slotted/hex head screws (C) on the sides of the cabinet.