Youwill be killed or seriously injured if you don’t follow instructions.
Youw be killed or seriously injured if you don’t follow instructions.
All safety messages will identify the hazard, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
Important: Observe all governing codes and ordinances.
Proper installation is your responsibility. Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with the clearances specified.
Check the location where the range hood will be installed. The location should be away from strong draft areas, such as windows, doors, and strong heating vents.
Tools and mate&Is needed for installation:
. compass or 7” | l | l- l/4” | drill bit |
| circle | template | l | pencil | | |
l | pliers | | 9 ruler | | |
l | level | | l | caulking | gun |
. | Phillips screwdriver | l | saber | saw |
l | metal | snips | l | keyhole | saw |
l | drill | | . | duct | tape |
Mobile home installation
The installation of this range hood must
conform to the Manufactured Home Construction Safety Standards, Title 24 CFR, Part 328 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD, Part 280) or when such standard is not applicable, the Standard for
Manufactured Home Installation 1982
(Manufactured Home Sites, Communities and Setups) ANSI A225 1/NFPA 501 A, or latest edition, or with local codes.
To connect to four-wire power supply, the appliance wiring must be revised. See Electrical requirements.
Copies of standards listed may be obtained from:
’National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
Electrical requirements
Important: Observe all governing codes and ordinances.
It is the customer’s responsibility:
To contact a qualified electrical installer.
To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSVNFPA 70 - latest edition*, and all local codes and ordinances.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
A n A 115-volt, 60-Hz, AC-only, fused electrical supply is required. The total ampere load used, including the range hood, must not exceed 90% of the rated capacity of the circuit. The ampere rating of the range hood is located on the model/serial rating plate located on the side cover of the motor housing.
B w The range hood must be connected with copper wire only.
wn The range hood should be
connected directly to the fused disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed copper cable. A U.L.-listed strain relief must be provided at each end of the power supply cable. Wire sizes (COPPER WIRE ONLY) and connections must conform with the rating of the appliance as specified on the model/serial rating plate.
Wire sizes must conform to the requirements of the National Electrical Code ANSI/NFPA 70 - latest edition*, and all local codes and ordinances.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable Codes and Standards, including Fire Rated Construction. The combustion airflow needed for safe operation of fuel-burning equipment may be affected by this unit’s operation. Follow the heating equipment
manufacturer’s guideline and safety standards such as those published by the National Fire Protection Association (NFPA),and the American Society of Heating Refrigeration and Air Conditioning Engineers (ASHRAE). and the local code authorities.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
Ducted fans must always be vented to the outdoors.
WARNING - To reduce the risk of fire, use only metal ductwork.
back v&t (RH2300 series only)
RH2000 and RH2300 series vent hoods can be used for vented installations only.
RH2600 series vent hoods can be used for non-vented (recirculating) installations only.
WARNING - To reduce the risk of fire or electrical shock do not use this fan with any solid-state speed control device.
WARNING -TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer. Before servicing or cleaning unit, switch power off at service panel and lock switch power off at service panel and lock service panel to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent warning device such as a tag to the service panel
CAUTION: For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.
WARNING -TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
Keep fan, filters and grease-laden surfaces clean.
Always turn hood ON when cooking at high heat.
Use high range settings on range only when necessary. Heat oil slowly on low to medium setting.
Don’t leave range unattended when cooking.
Always use cookware and utensils
appropriate for the type and amount of food being prepared.
WARNING - TO REDUCE TH RISK OF INJURY TO PERSONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:
SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
NEVER PICK UP A FLAMING PAN -You may be burned.
DO NOT USE WATER, including wet dishcloths or towels - a violent steam explosion will result. Use an extinguisher ONLY if:
You know you have a Class ABC extinguisher, and you already know how to operate it.
The fire is small and contained in the area where it is started.
The fire department is being called.
You can fight the fire with your back to an exit.
