Now start, Wiring requirements | Whirlpool 1157672 specs

A single-phase, 6OHz.

AC only, electrical supFjly is required on a separate circuit. A 15amp. time-delay fuse or circuit breaker is required. Copper wire (#14-gauge) is required.

The model and serial label is located behind the front panel on the base flange.

Specific electrical requirements are listed in the chart. Follow the requirements for the type of plug on the power supply cord.

Wiring requirements

rPlug Type A 1 Plug Type B

J-prong	l/4’ blade
grounding
plug
I

Dower	supply		cord	grounding		prong
115volt		-		230/2oa		~0tt	-
103.5~		min.,		197.6~ min.,
126.5~ max.				23%	max.
7Samp				12-amp		rating
ratings		or	less	or less	-	use	a
- a	double			single	outlet
outlet		is		and a	separate
acceptable.				circuit.

7.6 through

I2-amp ratings

-use only a ;ingle outlet and ;eparate circuit.

Recommended grounding method

Do Not, under any circumstances, remove the power supply cord grounding prong.

For your personal safety, this appliance must be grounded.

This appliance is equipped with a power supply cord having a 3-prong grounding plug. To minimize possible shock hazard. the cord must be plugged into a mating, 3-prong grounding-type wall receptacle, grounded in

accordance with the National Electrical Code, ANSI/NFPA

70-latest edition, and local codes

and ordinances. If a mating wall receptacle is not available, it is the personal responsibility and obligation of the customer to have a properly grounded,

3-prong wall receptacle installed by a qualified electrician.

Now start...

with air conditioner in room where it will be installed.

It is the customer’s responsibility and obligation to have this product installed by a qualified technician familiar with through- the-wall room air conditioner installations.

Check the air conditioner model number on the model/serial label located behind the front panel on the base flange.

If the air conditioner model num- ber starts with letters ACU, it must be installed into on air conditioner sleeve. It will fit into a Whirlpool sleeve, Model? AOW22W2, or a

comparable sleeve that is at least 19” deep. See THROUGH-THE-WALL SLEEVE INSTALLATION on bock cover.

If the air conditioner mO=del num- ber starts with letters other than ACU, instoll according to

THROUGH-THE-WALL INSTALLATICI\I

Appropriate

header if required

plaster
t
alternate	frame
construction	frame
for plaster	thickness
frame
construction
Appropriate
header if required	lintel
trim*%	lintel

alternate

constructione SS or plaster

brick veneer to ‘rame construction

1 When using a wood, metal n or plastic molding, the

frame should line up with the inside wall. If the plastered wall is to be flush with the cabinet and no molding is used, the frame must be set l/2-inch into the wall.

wall	Dimension		depends
	Dimension		depends
	on	wall thickness
	and	type	of molding.

2 Cut opening through the n wall. Remove insulation.

3 Use l-inch or heavier

n lumber for wood frome. Measure depth of wall opening and frame. Apply wood preservative to the outside, exposed surface.

Page 3