Whirlpool 1166073 If your air conditioner is not Operating properly, If you need assistance

Page 5

11 n Place drain cup through hole I .I .

in CabineT rall as snown.

Electrical Shock Hazard Grounding wire from the air conditioner must be connected to the cabinet.

Failure to do so could result in electrical shock.

12 n Insert air conditioner into cabinet. Reattach grounding wire to grounding screw. Put excess grounded wire between coil and grey beaded foam.

Part No. 1166073

0 1994

‘screivs

13 n Attach front by first mq

the two, #8 x 9.5mm (3/8”) screws from base; then insert front tabs into top of cabinet and swing front in place.

Attach bottom of front by reinserring the two screws.

14 w Caulk all outside wall openings around cabinet.

15 n If needed, install molding around room side of cabinet.

Benton Harbor, Michigan 49022

If your air conditioner is not

operating properly...

Check that the circuit breaker is not tripped or house fuse blown. Check that power supply cord is securely plugged into the electrical outlet.

If you need assistance...

Check your Use and Care Guide for a toll-free number to call, or call the dealer from whom you purchased this appliance. The dealer is listed in the Yellow Pages of your phone directory under “Appliances - Household - Major - Service and Repair. I

When you call, you will need the model number and serial number. Both numbers can be found on the model and serial label located behind the front panel on the front flange of the base.

Printed on recycled paper. 10% post consumer waste/ 50% recovered materials.

Printed in U.S.A.

Image 5
Contents Important Read and save these instructions Wfrhg requirements Before you startElectrical Panel B Window InstallationNow start Panel C THROUGH-THE-WALL InstallationIf you need assistance If your air conditioner is not Operating properly