Whirlpool 1166073 installation instructions Now start, Window Installation, Panel B

Now start...

Wii air conditioner in room where it will be installed

WINDOW INSTALLATION

See Panel C for Through-thewall installation.

Front view 01unil with front panel removed.

Dower-

c&b .

1 n Loosen, but Do Not remove grounding wire screw. Disconnect grounding wire.

Floor Damage

Remove air conditioner from carton and place on cardboard.

Failure to do so may cause damage to floor covering.

&mounting angle

Q

0\ seal

-

2 n Attach 9.5 mm (3/8”) seal strip to the bottom of both side

mounting angles (side with two holes). Cut strips to length.

/angle-

side view

5 n Place cabinet in window. Lower sash (window frame) to hold cabinet in place. Measure the distance between the side of the cabinet and inside of the window channel at the top and bottom of the cabinet. Adjust the cabinet until the distance on each side (top and bottom) isthe same, so the cabinet is centered in the window. Write down the final measurement.

+A2+			;cAl		--,
		I	I
+		I	I		+
		I	I
		I	I
		I	I
	right	I	:	left
		I
	tiller		I	tiller
	board	:	I	board
		I	I
		I	I
		I	I
		I	I
		I	I
		I	I
t		I	I
	82 4	I	I
e			+	81

6 n Add 3.2 mm (l/8”) to both open area measurements. Use utility knife to cut filler boards to fit.

back	of
filler
.board
7	ri ht
left
tiller	fil7 er
board	board

.	.
front of filler board	4
7 n Apply 9.5 mm (3/8”) seal strips to

bottom and outside of filler boards. The top seal goes on back side of filler boards.

10 n Insert other filler board into window channel on opposite side of cabinet. Push filler board against side- mounting angle and attach with

12.5mm (l/2”) hex-head screws. Raise window sash.

11 n From the outside, push filler boards as far forward in window channels as possible.

12 n Measure the distance between the channel edge and the filler board. Cut foam blocks 6.4 mm (l/4”) wider. Insert blocks into channel behind filler boards.

13 n Measure from inside edge of window frame to other inside edge. Cut foam seal with square ends to fit.

Align foam seal with front edge of window sash and attach seal with adhesive side against underside of sash.

Property Damage

Check that air conditioner cabinet is tilted to the outside so that water will run to the outside.

Failure to do so may cause damage to floor covering, window sill or wall.

on both sides.

14 n Lower window sash. Place level inside cabinet on the right side. There should be a tilt to the outside of approximately one bubble. Place the level on the left side and check.

3 n Attach side-mounting angle with two, hex-head, metal screws using

6.4mm (l/4”) socket and socket wrench or l/4” nut driver.

8 w Pull

cabinet part way out of window.

w Attach one filler board

to front of a sidemounting

angle with 12.5 mm (l/2”) hex-head screws.

15 n Use a 2.4 mm (3/32”) drill bit to drill starter holes in the cabinet and into the window sill. Fasten cabinet to the sill with two wood screws.

4 n Pull on handles; slide air conditioner out of cabinet and place on cardboard.

9 n Place cabir let back into the window with filler board tight against window channel.

Panel B