Lens Common -Connector | Bosch Appliances tc9346a specification

WARNING: Camera damage possible.You can damage your camera if you connect it to the wrong connector.

If your camera will use the same power as the enclosure, plug the camera into the CAM 1 socket on the circuit board.

If your camera’s voltage will be dif- ferent from the enclosure’s voltage, plug the camera into the CAM 2 socket. DO NOT plug the camera into the CAM 1 socket or you can damage your camera. CAM 1 has enclosure voltage on it.

BE CAREFUL - REMEMBER

CAM 1 IS ENCLOSURE

POWER

NEVER PLUG YOUR CAM- ERA INTO CAM 1 IF THE CAMERA’S VOLTAGE IS DIFFERENT FROM THE ENCLOSURE’S VOLTAGE.

b.Wire the 10-connector INPUTS terminal on the circuit board to the lens controller as follows:

•Lens Common -Connector 1

•Focus - Connector 2

•Zoom - Connector 3

•Iris - Connector 4

•Preset Common - Connector 5

•Preset Focus - Connector 6

•Preset Zoom - Connector 7

•Preset High - Connector 8

11.TC9346A-1, -2, -3 Models Only

Refer to Figure 2 and connect the camera’s power input to the circuit board.

There are two ways to supply power to the camera - when the power require- ments for the camera and enclosure’s accessories are the same (for example, if the camera and accessories use 24 VAC), and when the power require- ments for the camera and the enclosure’s accessories are different (for ex- ample, if the camera uses 24 VAC and the accessories use 120 VAC).

When the power requirements are the same, there are two ways to connect power:

(1)A three-pin plug is supplied as loose equipment. Connect the wires from the plug to the camera as follows:

Brown - AC HI Blue - AC NT Green - Ground

Connect the plug to the CAM 1 socket on the circuit board (remove the plastic cover over the power supply section of the circuit board).

(2)If both the camera and enclosure use 120 VAC and you ordered the op- tional 120 VAC electrical outlet accessory (O/I-OUTLET), connect the 120 VAC plug to the camera and the three-pin plug to CAM 1 (remove the plastic cover over the power supply section of the circuit board).

When the power requirements are different, connect the wires from the two- pin plug, which is supplied as loose equipment, to the camera as follows:

Brown - AC HI

Blue - AC NT

Connect the plug to the CAM 2 socket on the circuit board.

12.Wire power to the enclosure to operate the camera.

TC9346A Model Only – Wire power directly to the camera. If you are using 24 VAC, refer to Table A to determine the size of wire to use.

TC9346A-1, -2, -3 Models Only

•CAM 1 - If the camera’s power input is connected to CAM 1 on the circuit board, go to step 13.

•CAM 2 - If the camera’s power input is connected to CAM 2 on the circuit board, wire power for the camera as follows:

a.Connect AC high to connector 9 of the 10-connector INPUTS terminal block (goes to the brown wire in the CAM 2 connector).

b.Connect AC neutral to connector 10 of the 10-connector INPUTS termi- nal block (goes to the blue wire in the CAM 2 connector).