BEA FALCON XL dimensions Description of the Infrared Remote Control, Unlock, LED Signal

FUNCTIONS

1. DESCRIPTION OF THE INFRARED REMOTE CONTROL

FUNCTIONS

CONFIGURATION

CONFIGURATION

WITH REMOTE

WITH REMOTE

CONTROL

CONTROL

•Open the battery compartment at the back of the remote control;

•Insert two AAA batteries supplied with the remote control as shown beside;

•Close the batteries compartment.

Remark: For optimum results point the remote control at the sensor before pressing its buttons.

2. CONFIGURATION OF THE SENSOR

Each setting change using the infrared remote control must start with an unlocking and end with a locking of the sensor. It is important to point out that any parameters changed using the remote control supersede any previous setting.

The table below lists all the parameters, which can be adjusted with the remote control as well as the operations, required to adjust them.

PARAMETER					USER'S ACTIONS			FACTORY
	KEY							SETTING
		Press the UNLOCK Key (3).						0000
		Enter your four-digit access code using NUMBER Keys 0-9 (1).
UNLOCK		During the first sensor adjustment or if the access code is reset
		to the ‘0000’ value (factory setting) or during the first minute
		after the power-on, press only the UNLOCK Key (3) (no code
		required).
		UNLOCK with code					UNLOCK without code
			0-9	0-9	0-9	0-9
		When all the parameters have been set, press						0000
		the LOCK Key (10).
	LOCK	If you wish to enter a new access code, use NUMBER Keys
		0-9 (1) to enter the new four-figure code within 20 seconds.
		If no access code is entered or if you want to keep the current
		access code, press the LOCK Key (10) once more.
		If no remote control key is pressed within 1 minute, the
		adjustment session is automatically locked.

Pressing the LOCK Key (10) twice within the first minute after the power-on reset automatically the access code to 0000

value.
LOCK with code change					LOCK without code or
						Code change
	0-9	0-9	0-9	0-9

LED SIGNAL

The red LED flashes quickly waiting for the access code.

After entering the correct code or if no code is required, the red LED flashes slowly to indicate that the unlock is successful and the adjustment session has begun.

NOTE: = Adjustment session ON

The red LED stops flashing to return to its normal function.

75.5351.02 EN 20080317 (75.5350) Page 4 of 7