Audiovox CA 3051 ELIMINATING/RETURNING the NORMALARM/DISARM Chirps, Alarm Dash LED Indicators

Page 5

ELIMINATING/RETURNING THE NORMALARM/DISARM CHIRPS

You can selectively eliminate the normal arm & disarm chirps using the valet/ override switch, following these steps.

1.Turn the ignition key ON the OFF.

2.Within 10 seconds of turning the ignition key OFF, press and release the valet/override switch 3 times.

3.If, before step 1, the chirps were ON, then you will hear 2 short chirps, which indicates the chirps are turned OFF.

4.If, before step 1, the chirps were OFF, then you will hear 1 short chirp, which indicates the chirps are turned ON.

5.Whenever the system's power has been disconnected, the chirps will be ON when power is reconnected.

SYSTEM FUNCTIONS AT A GLANCE

ALARM DASH LED INDICATORS

 

RAPID FLASHING

=

PASSIVEARMING

SLOW FLASHING

=

ARMED

OFF

=

DISARMED

ON SOLID

=

VALET MODE

4 FLASH...PAUSE

=

INTRUSION SHOCK SENSOR

3 FLASH...PAUSE

=

INTRUSION DOOR

2 FLASH...PAUSE

=

INTRUSION HOOD OR TRUNK

ALARM SIREN CHIRP INDICATION

1

CHIRP*

=

ARM

2

CHIRPS*

=

DISARMED

3 CHIRPS

=

ARMING WITH ENTRY POINT OPENED

4 CHIRPS

=

DISARM AFTER INTRUSION

CONTINUOUS

=

ALARM TRIGGERED

ALARM PARKING LAMP INDICATIONS

1 FLASH

=

ARM

2 FLASH

=

DISARM

3 FLASH

=

DISARM AFTER INTRUSION

CONTINUOUS FLASH

=

TRIGGERED

ca3051 rev B. 2011Audiovox Electronics Corporation. All rights reserved.

Image 5
Contents Owner’s Guide Protection While the System is Armed Arming the SystemPassive Arming the System Disarming the System Intrusion Warning SignalVALET/OVERRIDE Switch Alarm Dash LED Indicators ELIMINATING/RETURNING the NORMALARM/DISARM ChirpsCode Systems, Inc. Limited Lifetime Warranty Page Audiovox Electronics Corporation Customer Service