3M 8800 Series System Operation, Turning your system on and off, Verifying system operation

Page 12

System Operation

Turning your system on and off

Power is applied and removed with a key switch located on Panel A. Two keys are supplied with the system. Remove the key while the system is operating to prevent patrons from turning off the system. If the key is not available and power must be removed, unplug the power cord or turn off the circuit breaker in the power distribution panel that supplies power to the system. Your detection system has been designed to be left on continuously.

Turning the system on

1Ensure that the power cord is connected to a power outlet or other source of power.

2Turn the key switch to the On position.

3Allow 10 seconds for the system to warm up.

Turning the system off

Remove power from the system by one of the following methods:

Method 1 Turn the key switch to the Off position.

Method 2 Disconnect the AC power cord from the power outlet.

Method 3 Set the facility circuit breaker for the system to the Off position.

Key Switch

AC Power Cord

8800_OM_005

Figure 2. Detection System Panel A

Verifying system operation

Your system should be inspected daily for proper operation. To verify system operation, walk through the system corridor with a secured library item. This should result in an audible alarm and a flashing alarm light at the top of the panels. There is no need for repetitive walk-through testing. During normal operation, the current patron count is displayed. Each pass through the system should increment the patron counter by one.

8

Image 12
Contents Detection System Model 8800 Series Page Table of Contents Page Safety Information Safety messages contained in this manualIntended Use To reduce the risks associated with hazardous voltageLabel Locations Detection System Model 8800 Series Label LocationsEMC, USA, and Canada Compliance FCC ID DGF-SSD8800Introduction Training your StaffGlobal leader in library systems products What this means to youWhat to do when the alarm sounds Hands-on practiceReview of your librarys security policies 3M offers these guidelinesAlarm log Unwanted alarmsSystem Specifications Cleaning InstructionsSystem Operation Turning your system on and offVerifying system operation Turning the system onResetting the patron counter To reset the patron counterTroubleshooting Adjusting audible alarm and patron counter displayPanel a Panel B Detection System Alarm Log Requesting Service 3M Service Phone NumbersUnited States Canada Other Countries