Magnadyne M7a user manual Chirp Indicators, Parking Lights, Alarm Operating Condition, LED Display

Turbo Timer Mode (Also See Installation Manual)

Turbo Timer Mode keeps the engine running after arriving at you destination for a programmable time period of 1, 3 or 5 minutes. This allows the system’s time to conveniently cool down the turbo after you have left the vehicle.

To Activate:

1.While the engine is running, set the emergency brake and place the transmission to "Park".

2.Before turning off the engine, press and release and buttons at the same time. The light will flash to indicate the remote start has entered Turbo Timer Mode.

3.Remove the “Ignition Key” from the key cylinder. The engine will keep running.

4.Exit and secure the vehicle. The Engine continues running until the pre-programmed time elapsed.

Chirp Indicators

Chirp		Function
1	Chirp	Arm
2	Chirps	Disarmed
3	Chirps	Defective Reminder
4	Chirps	Disarm / Triggered
6	Chirps	Car Locator

Parking Lights

Parking Lights		Function
1	Flash	Arm
2	Flashes	Disarmed
3	Flashes	Disarm / Triggered
12 Flashes		Car Locator
Constant On		Under Remote Control

Alarm Operating Condition

		Siren, Horn	Parking Light	LED	Doors	Starter	Dome Light
1.	Arming	1 or 3 Chirps	1 Flash	Slow Flash	Locking	Disable
2.	Disarming	2 or 4 Chirps	2 or 3 Flashes	Fast Flash	Unlocking		Turns on for 30 Seconds
3.	Trigger	Alarming	Flashes	Slow Flash		Disable	Flashes
4.	Panic	Alarming	Flashes				Flashes
5.	Car Locator	6 Chirps	12 Flashes

LED Display

LED	Function
Off	Disarmed
Slow Flash	Armed
Fast Flash	Passive Arming
On (Solid)	Valet Mode

LED	Function
2 flashes... pause	Zone 2: Trigger on Trunk/Hood
3 flashes... pause	Zone 3: Trigger on Door Switch
4 flashes... pause	Zone 4: Trigger on Optional Sensor
5 flashes... pause	Zone 5: Trigger on Ignition Switch

8