Tyco instruction manual PC1150 Keypad, Keypad Zones

PC1150 Keypad

The Zone Lights will come ON when the system is disarmed
to indicate that there is activity in a zone. Refer to the System
Information page at the front of this manual for zone information.							The “Ready” light will come ON to indicate
							that the system is ready to be armed.
							When the “Ready” light is OFF, there is an
							open zone on the system. All zones must
							be either secure or bypassed before the
			Zone 1		Ready
							system may be armed.
			Zone 2		Armed
			Zone 3		System
			Zone 4				The “Armed” light will come ON to
							indicate that the system is armed. To
			1	2	3		arm the system, first ensure that the
							“Ready” light is ON, then enter an
			4	5	6
							Access Code.
			7	8	9		The “System” light is used to indicate a
				0	# ACCESS		number of conditions on the system that
							may require attention before the system is
		PC115O					armed. When the “System” light is ON,
	DOC LN/MDC IC 2						check the following:
							• press [∗ ][1][9]		to	view	Bypassed
							Zones	[∗ ][2]
		Keypad Zones:					• press		to	view	Trouble
							Conditions
	Press [1]+[3] for 2 seconds to activate a Pulsed alarm						• press [∗	][3] to view the Alarm Memory
	Press [4]+[6] for 2 seconds to activate an Auxiliary alarm						Display
	Press [∗ ]+[#] for 2 seconds to activate a Panic alarm						Refer to this instruction manual for
	The Keypad Zones will not function unless they are enabled						complete instructions on using these
		by your Installer.					features.
							Press [#]...
							• when an error is made in entering
							code, then enter code again.
	Trouble Conditions: The “System” light will come ON when there is a fault on
							• to return to ready state after using
	the system. Press any key to silence the keypad sounder. Press [∗ ] then [2]
							[∗ ] commands.
	to display the trouble condition. Call for service if you are unable to correct a
	trouble condition.
		Light	Trouble Type			What to do
		Zone 1	Low battery			Call for service
		Zone 2	AC failure (keypad			Check fusebox for
			buzzer will not sound)			open fuses; call for service
		Zone 3	System Fuse open			Call for service
		Zone 4	Fail to communicate			Call for service
		“Ready”	Not used to indicate troubles
		“Bypass”	Clock needs resetting			Reset the system time

7