Firstech, LLC CM3000 installation manual Connector #4, Connector #5, + unlock output, Pin #5

Page 6

Firstech, LLC. Technical Data (CM3000)

Connector #4:

Pin #1: No Connection

Pin #2: Violet/White- this wire is the (-) 200mA trunk release. The following sequence takes place each time the trunk release output is triggered:

1.CompuStar disarms alarm and unlocks doors

2.Trunk output is triggered

Pin #3: Orange/Black- This wire provides you with the capability of adding driver’s door priority unlock similar to factory keyless entry systems. Please note that this feature requires more advanced installation. Please call Technical Support for details.

Pin #4: Blue- This wire is the (+) lock output that doubles as a (-) unlock output.

Pin #5: Blue/Black- This wire is the (-) lock output that doubles as a

(+) unlock output.

Pin #6: No Connection

Connector #5:

Pin #1: Orange- This is the Rearm wire. It provides you with a (-) pulse when armed, after remote start and then again one second after remote start shuts down.

Pin #2: Orange/White- This is the Disarm wire. It provides you with a (-) pulse when disarmed and before remote start.

Pin #3: Violet- This is the Dome light Supervision wire. It provides a (-) 200mA pulse to turn the dome light on for one minute after unlock. Please note: This feature is not available in manual transmission mode.

Pin #4: Brown- This is the (+) siren output wire. Connect this wire directly to the red wire on the siren.

Pin #5:

White- This is the (-) 250mA horn honk output wire.

6

Image 6
Contents CM3000 Guide to Installation Connector #1 Connector #2 Connector #3 Pin #7Pin #8 Tachometer Sensing Alternator Sensing+ unlock output Connector #4Connector #5 Pin #5Connector #8 Connector #6Connector #7 Connector #9Tach Learning Switch Dip SwitchesJumper Wire