I C - 4 0 0 - T , I C - 5 2 5 - T & I C - 6 5 0 - T
Thank you for purchasing your Klipsch
The
Before installing your speakers take a moment to check the contents of the cartons and make sure nothing has been damaged in transit.
3.To install the tilebridge, fold the rail side of the ring back upon itself using the spring tensioner on the reinforcement ring to allow insertion into the cutout hole. Once it is inserted into the cutout hole, release the reinforcement ring such that it unfolds back to its normal position. Position tilebridge over cutout hole, and insure that the tile rails rest on the
Contents Description
Speaker Modules Grille Reinforcement Ring Rails
Cardboard Cutout Template and Paint Mask Screws (Attach Rails to Reinforcement Ring) 3/4" Adapter Fittings
QUANTIT Y
2
2
2
4
2
8
2
1Installation. The tilebridge is composed of three
Caution: Be sure to comply with any and all building codes in your area.
2.To install your
IC - 400 - T, IC - 525 - T | 9.125 "Round |
|
|
|
|
IC - 650 - T | 10.125 "Round |
|
|
4.The wiring compartment is intended as a termination point for the audio circuit. Access to this compartment is gained by removing the terminal cover located on the back of the speaker. The terminal cover will accept the appropriate conduit/wire adapter (provided). Feed wires through conduit/wire adapter and connect to the input terminal according to the desired operation mode. Be sure to observe proper polarity. Replace the terminal cover and tighten the conduit/wire adapter to secure the wire.
Caution: When connecting 70V or 100V distributed line systems, take care to ensure proper terminal connection. Connection to the low impedance termi- nal could result in speaker damage, amplifier damage, or both.