Guardian Technologies GGU300 warranty Tool Assembly, Upright Mode, Converting to Canister Mode

TOOL ASSEMBLY

· Attach crevice tool, dusting brush and upholstery

brush into storage area on the back of the vacuum. (Fig. 8)

	Crevice
	Tool
Fig. 8	Dusting
	Brush
	Upholstery
	Brush

UPRIGHT MODE

USING IN UPRIGHT MODE

·Push the handle release pedal. (Fig. 9)

·Turn main power switch on. Turn brush power switch on.

Caution: The headlight and brush does not come on when in the upright position even if the switch is on. You must release the handle for the brushroll to begin spinning. (Fig. 10)

Base Safety

Switch

	Handle	Base
	Release
Fig. 9	Pedal	Fig. 10

CONVERTING TO CANISTER MODE

CONVERTING TO CANISTER MODE

·Remove hose from base hose connector. (Fig. 11)

·Step on release canister pedal and pull body upward by canister handle. (Fig. 12)

	Canister
	Handle
	Body
Hose
Base Hose	Release
Connector	Canister
	Pedal
	Base
Fig. 11	Fig. 12

6

CONVERTING TO CANISTER MODE (cont.)

·Push handle removal button and pull up on handle to disconnect from body. (Fig. 13)

·Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14)

·Push button on wand to extend telescoping wand. (Fig. 14)

·Insert end of handle into hard floor nozzle. (Fig. 15)

·Canister mode. (Fig. 16)

Handle

HandleHoseHose

Connector

Telescoping

Button

Handle

Removal

Button

Handle

Fig. 13 Fig. 14

Handle

Hard Floor

Nozzle

Fig. 15 Fig. 16

7