Kenmore 758.15408 manual Troubleshooting, Trouble Probable, Remedy

Troubleshooting,

	Trouble			Probable			Cause		Remedy
Digital	display not	illuminated.	•	No Power.				• Check	120 volt power source.
			•	Power	button has not been			• Press	power button	once to
				depressed,				turn on.
Fan not operating		(digital	•	ROOM	humidity		level is not	• Raise	SET humidity	level if
display	is illuminated).			3% or	more below SET			desired.
				humidity		level.
			•	Reservoir		is empty.		• Increase fan speed.
								• Fill humidifier with water.

Fan running continuously.	•	SET	humidity	level is 65%.
	•	ROOM humidity level has not
		reached 1% or more above
		SET	humidity	level.

•A SET humidity percentage of 65% operates fan

continuously. Adjust SET level between 25% - 60%.

•Continue to run until desired humidity level is achieved. This may take up to 48 hours initially.

Poor	evaporation of water.		• CHECK		FILTER message
				flashing,
			• Mineral buildup on filter.
Bottle	empties	completely.	• This is normal for initial filling.
Bottle	continues	to empty	•	Air is entering			water bottle.
after	complete	filling.
Bottle	not emptying.		•	Spring	Valve		Assembly
				damaged		or missing post
				in bottom		of base.

• Base full of water.

•Change to a fresh new filter.

NOTE: Local water purity varies from area to area.

•Refill bottle for maximum run time.

•Check for leak in water bottle.

•Check orientation of bottle. Reposition so that fill valve on bottom of bottle is depressed by post in bottom of base.

•The base will hold the

contents of water bottle (1.2 gallons). Continue to run

humidifier to deplete water from base.

12