Klipsch owner manual CP-T Series, WHAT’S Inside

CP-T SERIES

Thank you for your purchase of the Klipsch CP-T Series 70/100 Volt speakers! They are designed to both withstand the rigors of outdoor use while also complimenting any indoor décor. The 90°x 90° horn dispersion pattern assures wide, even coverage with either horizontal or vertical placement. The long-throw woofers are combined with front-firing ports for tight, musical bass no matter how they are mounted or placed. The included, unique speaker bracket allows for not only quick vertical or horizontal mounting but also allows for tight, wall/wall or wall/ceiling corner mounting for a highly aesthetic look that allows for increased overall bass output.

The CP-4T contains a high quality, built-in 70/100 Volt transformer with a single, fixed 5/10 watt tap while the CP-6T contains a 70/100 Volt transformer with multiple tap settings of 3.75/7.5 watts, 7.5/15 watts, 15/30 watts and 30 watt taps. The CP-6T also has an 8 ohm bypass setting for 8 ohm operation.

WHAT’S INSIDE

To mount speaker vertically in corner PUTTING BRACKET ON LEFT WALL against corner put THIS SIDE flush in corner on left wall and mark vertical pilot holes

MAKE SURE TEMPLATE IS LEVEL

BEFORE DRILLING PILOT HOLES!

Vertical

Pilot Hole

To mount speaker HORIZONTALLY UP in ceiling/wall corner putting bracket on wall put THIS SIDE on wall flush against ceiling and mark horizontal pilot holes	SURE TEMPLATE IS LEVEL BEFORE DRILLING PILOT HOLES!	Horizontal	Pilot Hole
	MAKE
		Horizontal	Pilot Hole

Mount Wall Bracket Template for CP-4/4T

Vertical

Pilot Hole

					To mount speaker vertically in corner PUTTING
					BRACKET ON RIGHT WALL against corner put
					THIS SIDE flush in corner on left wall and mark
					vertical pilot holes
Speakers (x2)	Brackets (x2)	Grills (x2)	Bracket Retaining	Mounting Template		Grill Remover Tool
			Screws (x4)