1.Unplug cord from wall outlet. DO NOT drip water on cleaner.
2.Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid detergent and water, then wrung dry. Wipe dry after cleaning.
3.To reduce static electricity and dust build- up, wipe outer surface of cleaner and attachments.
Do not use attachments if they are wet. Attachments used in dirty areas, such as under a refrigerator, should not be used on other surfaces until they are washed. They could leave marks,
iliiiiiiliiiiiiii!iiiiiiiii!i!i!iiiiiiiii!ii!!iiiiii;8 i i i ! ii iiiii i iE! i i i i i iii
Check motor safety filter occasionally and change when dirty.
Electrical Shock Hazard
Unplug power cord from electrical outlet, Do not operate the cleaner without the motor safety filter. Be sure the filter is dry and properly
installed to prevent motor failure and/or electrical shock.
Remove the bag as outlined in the BAG CHANGING section.
MOTOR SAFETY FILTER ELECTROSTATIC
This white filter must be replaced when
1.Lift the rubber
retainer and pull out motor safety filter as shown.
Rubber Retainer
#//
2.Replace the fil- ter, white side out,
facing the dust bag, by sliding it back into place under the ribs in the bag cavity. Tuck filter in so that it fits com-
pletely under the rubber retainer.
dirty. It should be replaced regularly depending on use conditions. The filter
CANNOT be washed as it will lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for
motor safety filter number.
3.Replace the bag as outlined in the BAG CHANGING section.
14