Kenmore 580.71056 owner manual Removal from Window, Install the AIR Conditioner

r_ INSTALL THE AIR CONDITIONER IN THE

WINDOW

•Carefully lift the air conditioner and slide it into the open window. Make sure the bottom guide of the air conditioner drops into the notches of the L brackets.

•When the air conditioner drops into the L brackets,

the air conditioner will be centered in window opening as shown in FIG. 7.

•While steadying the air conditioner, carefully bring the window sash down behind the upper guide of the air conditioner, as shown in FIG. 8.

:m

CENTER LINE FIG. 7

FIG. 8

_-_SECURE THE GUIDE PANELS

Extend the guide panels (ITEM F) to fill the window opening using 4 screws (ITEM B) to secure them, as shown in FIG. 9.

_J INSTALL THE SASH SEAL AND SASH LOCK

•Cut the sash seal (ITEM E) to the window width. Stuff the sash seal between the glass and the

window to prevent air and insects from getting into the room, as shown in FIG. 9.

•Fasten the remaining L bracket on either side of the window using screw (ITEM A). See FIG. 9 inset. Installing this bracket prevents window from being raised which may result in unit falling,

_IlF AIR CONDITIONER IS BLOCKED BY

STORM WINDOW FRAME

-If storm window presents interference, fasten a 2" wide wood strip to the inner window sill across the full width of the sill. The wood strip should be thick enough to raise the height of the window sill so that the unit can be installed without interference from the the storm window frame. See FIG. 10.

Top of wood strip should be approximately 3/4" higher than the storm window frame to help condensation to drain properly to the outside.

•Install a second wood strip (approximately 6" long by 11/z" wide and same thickness as first strip) in the center of the outer sill flush against the back of the

inner sill. Screw the L brackets into this strip. This will raise the L bracket as shown in FIG. 10.

WOOD STRIP MOUNTED	1" MAX.
ON TOP OF INNER SILL	"4"-I	_	3/4"	1
_	I	[	CLEARANCE,
			STORM

FIG. 10

REMOVAL FROM WINDOW

Turn the air conditioner off, and disconnect the

power cord. Remove the L bracket and the screws

installed through the top and bottom of the guide panels, and save for reinstallation later. Close the

guide panels. Keeping a firm grip on the air conditioner, raise the sash, and carefully tilt the air conditioner backward, draining any condensate water. Lift the air conditioner from the window and remove the sash seal from between the windows.

• BRACKET

•Air conditioners covered in this manual pose an excessive weight hazard. Two or more people are needed to move and install the unit. To prevent injury or strain, use proper lifting and carrying techniques when moving unit.

•When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front and rear coils.

•Make sure air conditioner does noi fall during

FIG. 9 removal.

-7-