installation
Keypad installation
1.Ensure it is possible to run the wire to the location you have chosen.
2.To install a
3.Route
4.Terminate the
5.Ensure the
6.Source labels must be inserted prior to installing the trim plate on the keypad. Determine the system’s source names and numbers (e.g., CD, Source 1).
7.Select the corresponding source name label from the included label sheets.
8.Slide the label into the window slot until the source name is centered in the window.
9.Push any extra cable back into the wall or electrical box. Align the keypad back plate and screw the keypad to the electrical box.
10.Place the foam around the keypad face and then align and screw on the trim plate to the keypad.
- Right Side
- Left Side |
CA4 Keypad (front)
Jumper to enable firmware updates
Normal mode - Jumper OFF
Jumper ON - update mode
CAT-5 with
CA4 Keypad (rear)
Russound CA4 System Installation Manual | 15 |