Kenmore 153.318131, 153.318031 owner manual Filling the Water Heater, Converting the Element

Page 10

Installation Instructions (cont'd)

Filling the Water Heater

A CAUTION

J

Never usethis water heater unlessit is completely full of J

water. To prevent damage to the tank and heating ele- J ment, the tank must be filled with water. Water must J

flow from the hot water faucet before turning "ON" power.

_lb fill the water heater with water:

,Close the water heater drain valve by turningthe handle to the right (clockwise). The drain valve is on the lower front of the water heater beneath the small access panel.

,Open the cold water supply valve to the water heater.

NOTE: The cold water supply valve must be left open when the water heater is in use.

*lb insure complete filling of the tank, allow air to exit by

opening the nearest hot water faucet. Allow water to run until a constant flow is obtained. This will let air out of the water

heater and the piping.

Check all new water piping for leaks. Repair as needed.

Converting the Element

These instructions only cover the conversion of the convertible element, read this entire Manual before attempting to install or operate the water heater. The water heater is factory set to oper-

ate at 3800 watts. The element can be converted to operate at 5500 watts. Refer to the "Facts to Consider About the

Convertible Element" section.

The element of the water heater can be converted from opera- tion at 3800 watts to 5500 watts on a 240 volt system.

If after reading these instructions and this Manual, if you do not understand any portion, call the Sears Service Center.

NOTE: Whether or not the element conversion is made the

model rating plate must be marked. Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel.

Necessary element conversion parts are located in a small bag

contained within the electrical junction box on top of the water heater tank cover.

CONVERSION PARTS

SCREW

BUSS BAR

1.Before beginning the conversion turn "OFF" electric power supply tothe water heater.

AWARNING

Before making the conversion to 5500 watts, check the

(I)power supply...mustbe 240 volts, (2) wiring...10 gauge AWG, Type TW, 60°C or equivalent, and (3) Circuit

breakers or fusing...capableof 30 amp loading. Also, the installation must conform with this Manual, local codes

and electric utility rules. Failure to comply can result in

DEATH, SERIOUS BODILY INJURY OR PROPERTY DAMAGE.

AWARNING

HAZARD OF ELECTRICAL SHOCK! Before removing any access panels or servicing the water heater, make sure the electrical supply to the water heater is turned "OFF". Failure to do this could result in DEATH, SERI-

OUS BODILY INJURY, OR PROPERTY DAMAGE.

10

Image 10
Contents Owners Manual ListedAwarningj Safety PrecautionsAwarning Contents Product Specifications Customer ResponsibilitiesBasic Tools When Sweat SolderingAdditional Tools Needed Installation Instructions Removing the Old Water HeaterFacts to Consider About the Location Installation Instructions contdFacts to Consider About The Convertible Element Water Piping Installation Completed Using the Installation KITPipe Temperature-Pressure Relief Valve Conversion Parts Screw Buss BAR Filling the Water HeaterConverting the Element DEATH, Serious Bodily Injury or Property DamageConverting the Element contd Property DamageWiring Diagram NJURY,OR Property DamageWiring Installation Checklist Temperature Settings Service and AdjustmentTemperature Regulation Thermostat AdjustmentDraining Temperature-Pressure ReliefContd OUS BOD LY NJURY,OR Property DamageService and Adjustment contd Element Cleaning ReplacementElement Cleaning Replacement contd Service Drain Valve Washer ReplacementOUS Bodily INJURY,OR Property Damage Thermal Expansion Troubleshooting GuideStart Up Conditions Strange SoundsSmelly Water Troubleshooting Guide contdHigh Temperature Shut OFF System AIR in HOT Water FaucetsNot Enough or no HOT Water Water is TOO HOTLeakage Checkpoints Page Page Parts Order List Kenmore the Economizer 6 Table TOP Electric Water HeatersParts Order List contd Full ONE YFR Warranty on Water Hekfer Master Protection Agreements

153.318131, 153.318031 specifications

The Kenmore 153.318031 and 153.318131 are contemporary models of dishwashers that combine sophistication with functionality. Known for their efficiency and innovative features, these machines are designed to enhance kitchen experience while delivering exceptional cleaning results.

One of the main features of the Kenmore 153.318031 and 153.318131 is their impressive washing performance. Equipped with powerful jets and a multi-stage washing system, these dishwashers ensure that every dish, from heavily soiled pots to delicate glassware, is cleaned thoroughly. The advanced spray technology allows water to reach all corners of the dishwasher, ensuring that no food particles are left behind.

Energy efficiency is a noteworthy characteristic of these models. Both dishwashers are designed to operate with minimal electricity and water usage, making them a sustainable choice for environmentally conscious consumers. They are compliant with ENERGY STARĀ® ratings, underscoring their commitment to reducing energy consumption without compromising on performance.

Another striking feature of the Kenmore 153.318031 and 153.318131 is their spacious interior. With adjustable racks and multiple loading options, users can easily customize the arrangement to fit various dish sizes and shapes. The flexibility offered by these models allows for maximum use of interior space, making them ideal for families or those who entertain frequently.

The control panels are user-friendly, often featuring intuitive touch controls and a digital display that offers complete cycle information at a glance. With multiple wash cycles and settings to choose from, users can select the optimal washing program for their specific needs, including options for heavy, normal, quick, and eco-friendly cycles.

Noise reduction technology is another hallmark of these dishwashers. Engineered to operate quietly, the Kenmore 153.318031 and 153.318131 ensure that users can run them at any time without interrupting the household's daily activities or conversations.

In terms of design, both models boast a sleek and modern aesthetic, available in several finishes to match various kitchen decors. Their solid construction not only lends them an attractive appearance but also ensures durability and longevity.

Overall, the Kenmore 153.318031 and 153.318131 are designed to meet the diverse needs of today's households. Combining practicality with cutting-edge technology, they deliver on the promise of cleanliness and efficiency, making them an excellent investment for any kitchen.