ADT Security Services 3000EN manual 6LQJOH%XWWRQ$UPLQJ, Key First Press Second Press Third Press

2. The touchpad begins beeping and displays the armed message. The red ARMED indicator also lights.

6LQJOH%XWWRQ·6WHSµ$UPLQJ

8 CODE

ADT3000-007-V0

* READY

D

0

#

C

9 CHECK

7 INSTANT

B

6 BYPASS

4

5

A

3 STAY

2 AWAY

1 OFF

Before arming, close all perimeter doors and windows.

1. Press and hold the assigned function key for 2 seconds (no code is required). Function keys are shown below.

$UPLQJWKH6\VWHP

6LQJOH%XWWRQ$UPLQJ

The “A”, “B”, “C”, and/or “D” keys on your touchpad may have been programmed for single-button arming. Note that while it will not be necessary to use a security code for arming, a security code must always be used to disarm the system.

If Single-Button Arming is programmed:

• A function key has been assigned to a specific type of arming: STAY mode, Night-

STAY mode, AWAY mode, or STEP-ARMING (see Step-Arming6)%(=-7%61)(paragraph)83%61.

• You DO NOT need to enter your security code before pressing the function key (but you always need your security code to DISARM the system).

English%61)(Display:￿￿￿%;%=Green￿￿￿LED lit

TEST

=391%=)<-823;

English Display: AWAY

Single-Button “Step” arming may have been programmed into one of the lettered keys (A, B, C, or D). Check with your installer to see if this has been done in your system.

If Step-Arming is programmed:

•The assigned key provides a choice of three levels of security.

•The selected key can be pressed once, twice, or three times, increasing the level of security with each press, as follows

Key	First Press	Second Press	Third Press
Ø	Ø	Ø	Ø
A, B, C, D	Armed-STAY	Armed Night-STAY	Armed-AWAY
		(if programmed)

– 17 –