Heat & Glo LifeStyle 7000XLT manual Safety and Warning Information

Page 2

SAFETY AND WARNING INFORMATION

!before starting the installation. FAILURE TO FOLLOW these installation instructions may result in a possible fire hazard and will void the warranty.

!Prior to the first firing of the fireplace, READ the Using Your Fireplace section of the Owners Guide.

DO NOT USE this appliance if any part has been

!under water. Immediately CALL a qualified service technician to inspect the unit and to replace any part of the control system and any gas control which has been under water.

!THIS UNIT IS NOT FOR USE WITH SOLID FUEL. Installation and repair should be PERFORMED by a

!qualified service person. The appliance and venting system should be INSPECTED before initial use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding material, etc. It is IMPERATIVE that the unit’s control compartment, burners, and circulating air passageways BE KEPT CLEAN to provide for adequate combustion and ventilation air.

Always KEEP the appliance clear and free from

!combustible materials, gasoline, and other flammable vapors and liquids.

!NEVER OBSTRUCT the flow of combustion and ventilation air. Keep the front of the appliance CLEAR of all obstacles and materials for servicing and proper operations.

Due to the high temperature, the appliance should

!be LOCATED out of traffic areas and away from furniture and draperies. Clothing or flammable material SHOULD NOT BE PLACED on or near the appliance.

!Children and adults should be ALERTED to the hazards of high surface temperature and should STAY AWAY to avoid burns or clothing ignition. Young children should be CAREFULLY SUPERVISED when they are in the same room as the appliance.READ and UNDERSTAND all instructions carefully

These units MUST use one of the vent systems

!described in the Installing the Fireplace section of the Installers Guide. NO OTHER vent systems or components MAY BE USED.

This gas fireplace and vent assembly MUST be

!vented directly to the outside and MUST NEVER be attached to a chimney serving a separate solid fuel burning appliance. Each gas appliance MUST USE a separate vent system. Common vent systems are

PROHIBITED.

INSPECT the external vent cap on a regular basis to

!make sure that no debris is interfering with the air flow.

!The glass door assembly MUST be in place and sealed, and the trim door assembly MUST be in place on the fireplace before the unit can be placed into safe operation.

DO NOT OPERATE this appliance with the glass

!door removed, cracked, or broken. Replacement of the glass door should be performed by a licensed or qualified service person. DO NOT strike or slam the glass door.

!The glass door assembly SHALL ONLY be replaced as a complete unit, as supplied by the gas fireplace manufacturer. NO SUBSTITUTE material may be used.

!DO NOT USE abrasive cleaners on the glass door assembly. DO NOT ATTEMPT to clean the glass door when it is hot.

Turn off the gas before servicing this appliance. It is

!recommended that a qualified service technician perform an appliance check-up at the beginning of each heating season.

!Any safety screen or guard removed for servicing must be replaced before operating this appliance.

2

Image 2
Contents Installers Guide What to do if you smell gasSafety and Warning Information Table of Contents Service Parts Robertshaw Valve 111 710 NGK-6XLB Appliance Certification High Altitude InstallationsInstallation Codes CertificationANY Such Action MAY Possibly Cause a Fire Hazard Pre-install PreparationIntroducing the Heat-N-Glo Gas Fireplaces Diagram of the 7000XLT and 6000XLTB Space Requirements Locating the FireplaceFraming the Fireplace Clearance RequirementsFraming Dimensions 32 156mm 187mm Straight UP Vertical Venting Installing the Vent SystemNents MAY be Used Venting with ONE 1 90 Elbow Venting with Two 90 Elbows Venting with Three 3 90 Elbows Installing Vent Components Attach the First Vent Component to the Starting CollarsTo install support brackets for horizontal runs To Install the Heat ShieldInstall Support Brackets Continue Adding Vent Components12 Hole and Vent Pipe Ceiling Firestop Ceiling Side Attic FirestopVent Termination Pointing UP=VENT Terminal =AIR Supply Inlet Minimum for vinyl clad soffitsMinimum Height from Roof to Lowest Discharge Opening Securing of a Fireplace Positioning, Leveling, and Securing the FireplaceGas Control System Standing Pilot Ignition SystemGas Supply Line Gas Pressure RequirementsOptional Accessories Wiring the FireplaceFor Standing Pilot Ignition Wiring Appliance Requirements Remote Wall SwitchFinishing Hearth ExtensionsInstalling Trim, Logs, and Ember Material CeramicBefore Lighting the Fireplace After the InstallationDouble-check for faulty components Lighting the FireplaceFireplace Maintenance Important Turn OFF the GAS Before Servicing Your Fireplace

7000XLT specifications

The Heat & Glo LifeStyle 7000XLT is an innovative gas fireplace that combines style, efficiency, and technology, making it a popular choice for homeowners seeking to enhance their living spaces. With a sleek design and impressive performance, the LifeStyle 7000XLT captures the aesthetic appeal of a traditional fireplace while providing the convenience of modern heating solutions.

One of the standout features of the LifeStyle 7000XLT is its expansive viewing area. The fireplace boasts an impressive 50-inch wide glass front that allows for an unobstructed view of the flames, creating a stunning focal point in any room. The large glass surface not only enhances the visual appeal but also maximizes the heat output, ensuring that the room is efficiently warmed.

This model integrates advanced technology to provide homeowners with a tailored heating experience. The IntelliFire ignition system is a state-of-the-art feature, offering reliable and efficient lighting of the fireplace. This system eliminates the need for matches or lighter fluid, providing a hassle-free experience each time the fireplace is used. Additionally, the remote control capability enables users to adjust the flame height and heat settings with ease, adding a layer of convenience to the fireplace operation.

The LifeStyle 7000XLT is designed with energy efficiency in mind. It features a direct vent system, which allows for the safe and efficient venting of combustion gases. This not only enhances indoor air quality but also optimizes heat retention within the home. The fireplace achieves high-efficiency ratings, making it an eco-friendly heating option that helps reduce energy costs.

In terms of customization, the Heat & Glo LifeStyle 7000XLT offers a variety of styles and finishes. Homeowners can choose from different faces, accent lighting, and decorative media options, such as logs, stones, or glass, to create a unique look that complements their interior décor.

Safety is a paramount concern in modern fireplaces, and the LifeStyle 7000XLT does not disappoint. It is equipped with a safety pilot system that automatically shuts off the gas supply if the flame goes out, ensuring peace of mind for users.

In conclusion, the Heat & Glo LifeStyle 7000XLT is a remarkable gas fireplace that offers an exceptional blend of style, technology, and efficiency. Its large viewing area, advanced ignition and control systems, energy-efficient design, customization options, and safety features make it an excellent choice for any homeowner looking to create a warm and inviting atmosphere.