Figure 5
INSTALLATION
Subwoofer firing | Mounting | |
Flange | ||
into the wall | ||
exposed | ||
or floor | ||
|
SafetyWarning
To avoid potential injury, or possible death, from forward movement of the enclosure during abrupt stops or accidents, the enclosure must be properly installed and securely fastened to your vehicle. You are solely responsible for securely fastening the enclosure in your vehicle.
Mounting
Flange tucked under the enclosure
| Subwoofer firing |
| away from the |
Figure 6 | wall or floor |
4 | KMCOAXIALSPEAKER |
Wiring
Remove the cover for the speaker terminal cup, plug your subwoofer speaker wire into the terminals, using the red connector as positive and the black connector as negative. Connect the other end of the wire to your subwoofer amplifier in accordance with its owner's manual. Replace the cover for the speaker terminal cup, by snapping it into place. See Figure 7.
Figure 7
Speaker Terminal
Cup Cover
Performance |
|
| PERFORMANCE |
|
|
| |
Model: | SKM10 |
|
|
Nominal Impedance [Zn], ohm [per enclosure] | 4 |
|
|
Power Handling* Watts, Peak (RMS) | 300 (150) |
|
|
Enclosure Depth, in (cm) | 8 5/16 (21.1) |
|
|
Enclosure Height, in (cm) | 16 1/16 (40.8) |
|
|
Enclosure Width, in (cm) | 23 15/16 (67.4) |
|
|
Note: The use of a subsonic filter will significantly increase the power handling. |
|
|
|
The power handling specifications in these charts are calculated using a 25Hz, 24dB per octave subsonic filter. |
|
| |
*Power Handling Watts RMS without subsonic filter: |
|
|
|
Kicker Marine speakers use the highest level of magnetic shielding available to minimize compass and gauge deviation in your dash. |
|
| |
Kicker Marine speakers meet or exceed industry standards for environmental humidity and corrosion, | 5 | ||
and for material degradation due to UV exposure. |
| ||