Lamp Replacement – SP520 & SP920
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE REMOVING LAMPS.
Warning - The lamps reach high temperatures during operation. For this reason, allow the lamps to cool down after switching off the appliance.
The front panel will need to be removed in order to change lamps – see Fig. 12.
Warning - The front panel is heavy and easily damaged.
The front panel is supported at the top by the chassis and held tight by magnets at the top and bottom on the SP520 model. On the SP920 the front panel is held at the bottom by a fixing screw.
To gain access to lamps please apply the following procedure:
Remove the fixing screw from the base of the front frame on the SP920 - see Fig. 12.
While holding the front panel by its sides with both hands, carefully tilt the bottom of the frame outwards until free and then lift the panel up (1) and then away (2) from the main body - see Fig. 12.
To gain access to the bulbs remove the screws at ‘A’ to remove the cover bracket ‘X’ and the screws at ‘B’ to remove the cover bracket ‘Y’ - see Fig. 10a.
For access to the bottom bulbs, carefully slide the flexible rotisserie (see ‘a’ in Fig. 11) to one side ensuring that the rubber grommet is not lost (see ‘b’ in Fig. 11).
Remove the defective lamp by unscrewing it (see Fig. 11).
Replace with a 60W E14 SES Clear Candle bulb, rotating it. Take care not to
Steps for reassembling the heater
1.Refit the rotisserie making sure that the rubber grommet is carefully pushed into the slotted hole on the axial bracket.
2.Replace the cover brackets ‘X’ and ‘Y’ - see Fig. 10a.
3.Replace the front by aligning the slots on the front frame and making sure that it catches fully on the support brackets.
The magnets on the chassis will hold the front flush to the main body (SP520).
4.Replace the fixing screw on the base of the front frame (SP920).