Desa (V)VC36PE, (V)VC36NE Wiring Diagram, Operating Fireplace, Lighting Instructions

WIRING DIAGRAM

OPERATING FIREPLACE

For Your Safety Read Before Lighting Lighting Instructions

23

WIRING DIAGRAM

PILOT

IGNITOR LEAD

ORANGE

LIGHTING

INSTRUCTIONS

NOTICE: During initial operation of new heater, burn- ing logs will give off a paper-burning smell. Orange flame will also be present. Open damper or window to vent smell. This will only last a few hours.

				BLUE		1.	STOP! Read the safety information, column 1.
	E12		SYNETEK CONTROLS	TRANSFORMER		2.	Turn off all electric power to the appliance.
		IS1070B		WHITE		3.	Turn wall switch to the OFF position.
EV1	E8			24V AC	120V AC
	E6					4.	Open lower louver panel.
	E4							to the OFF
						5.	Turn equipment shutoff valve clockwise
	E3
	E2
			INC	BLACK			position (see Figure 42). Do not force.
				GROUND		6.	Wait five (5) minutes to clear out any gas. Then smell for
EV2				RED
							gas, including near the floor. If you smell gas, STOP! Fol-
	GREEN
							low “B” in the safety information in column 1. If you donʼt
							smell gas, go to the next step.	to
						7.	Turn equipment shutoff valve counterclockwise
							the ON position. Do not force.
						8.	Close lower louver panel.
OPERATING FIREPLACE						9.	Turn on all electric power to the appliance.
						10.	Turn the wall switch to the ON position.

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the pilot by hand.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch.

•Do not use any phone in your building.

•Immediately call your gas supplier from a neighborʼs phone. Follow the gas supplierʼs instructions.

•If you cannot reach your gas supplier, call the fire department.

11.Visually locate the pilot. The ignitor should begin to spark and the main burner should ignite once flame appears at pilot.

•If lighting the appliance for the first time each season, it may take several attempts before the supply gas can reach the pilot and main burners.

•If the appliance will not stay lit after several attempts, follow the instructions To Turn Off Gas To Appliance, page 24 and call your service technician or gas supplier.

	Pilot
Equipment	Adjustment
Shutoff	Screw
Valve

Figure 42 - Turning Equipment Shutoff Valve to the OFF Position

C.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

116235-01C www.desatech.com