Jwin instruction manual Pairing i903 with your Mobile Phone or Audio Device

Noise-Canceling Headset w/ Bluetooth wireless technology V10M10_IM_EN_12072006

OPERATING INSTRUCTIONS

Pairing i903 with your Mobile Phone or Audio Device

Before using this headset, make sure that it is paired with a mobile phone and audio devices with Bluetooth wireless technology. To pair with such a device, follow the instructions below:

1.Please make sure the headset is at standby mode. If i903 is currently turned on then press the Multi- Function button for approximately five (5) seconds. There will be a high-pitched beep with red light flashes about 4 times and headset will go into standby mode.

2.Press and hold the Multi-functionbutton for approximately five (5) seconds until the red and blue lights blink alternately around the button. The headset is now ready for pairing. (Note: Pressing the Multi-functionbutton longer than five (5) seconds will turn off the headset. If this fails, then turn off the headset and turn it on again by holding the Multi-Function button for five (5) seconds for pairing mode)

3.Set your mobile phone or audio device to its pairing mode (phones and audio devices with Bluetooth wireless technology will have their own pairing instructions. See owner’s manual of the phone or device for these instructions).

4.Place the mobile phone or audio device and the i903 close together during pairing. The mobile phone and most audio devices will detect i903 and identify it, displaying the model number i903.

5.Once the i903 has been identified, confirm as per the instructions on the device. You will be required to enter a password on the next screen.

- 13 - www.i-Luv.com