Desa W32WP Assembling Mantel, For installation with dimplex electric fireplace only

Page 2

Assembling Mantel

IMPORTANT: More than one person is required to lift assembled mantel. Lift mantel by leg assemblies. Lifting by header or mantel top could damage mantel.

1.Some models require side/corner assembly. For these models, lay leg front on soft cloth on floor. Position leg as shown in Figure 1. Align bottom and attach with 1 1/4" screws through pocket holes. Repeat for other side.

2.Each leg assembly will use 3 brackets for stability. Your bracket hardware kit will contain either 1/2" or 3/4" screws. Using 1/2" or 3/4" screws, install a bracket in the center of each leg assembly and one at each end within 1" of but not over the last pocket hole (see Figure 2).

3.Place header between right and left leg assemblies (see Figure 3). Make sure header and legs are snug against each other. The top of the header must be flush with the top and sides of leg assemblies. Attach header through predrilled holes with 1 14" screws on each leg assembly as shown in Figure 3. Attach flat brackets with 1/2" or 3/4" screws using 1 flat bracket and 4 screws per side (see

Figure 4).

1 1/4" Screws

Leg Side

Leg Front

Figure 1 - Assembling Legs

Bracket

1/2" or 3/4"

Screw

Figure 2 - Installing Brackets

Left

Header

Side Leg

 

Assembly

 

Top of

Mantel Right

Side Leg

Assembly

 

Figure 3 - Installing Header

Leg

1/2" or 3/4" Screws

Assembly

 

 

Flat

 

Bracket

 

Header

 

1 1/4" Screws

 

Figure 4 - Installing Header and Brackets

For installation with dimplex electric fireplace only

If installing with a gas fireplace, proceed to Attaching Top of Mantel, page 3.

1.Locate Dimplex filler components and gather tools required for assembly.

WARNING: Only use 1 1/4" screws to assemble Dimplex kit pieces. Damage to the mantel will result if other screws are used for this purpose.

2.Place large header portion face down on a soft surface.

3.Using 1 1/4" screws provided, attach short blocks to both ends of Dimplex header (see Figure 5, page 3).

4.Using 1 1/4" screws provided, attach long block to top edge of Dimplex header (see Figure 5, page 3).

CAUTION: When attaching blocks be careful that they do not spin with drill. This may cause injury.

5.Place mantel face down on soft surface.

6.Place Dimplex kit header into space below mantel header (see Figure 6). Push the kit header tightly against mantel header and attach blocks to mantel using 1 1/4" screws provided.

7.Carefully set mantel upright.

www.desatech.com

119939-01A

Image 2
Contents Assembly and Installation Instructions Wall Mantel and Base with TrimFor installation with dimplex electric fireplace only Assembling MantelAttaching Top of Mantel Attaching Blocks to Dimplex HeaderClose louver door Installing FireplacEAssembling metal Trim Included with Gas Fireplace Repisa de pared y base con adorno Instrucciones DE Ensamble E InstalaciónColoque cuidadosamente la repisa en posición vertical Ensamble de la repisa para chimeneaPara instalación en chimeneas eléctricas Dimplex únicamente Cómo fijar la parte superior de la repisa para chimenea Retire el embalaje de las tres piezas del adorno metálico Ensamble del adorno de metal incluido con la chimenea a gasInstalación de la chimenea