Desa W32WP installation instructions Attaching Top of Mantel, Attaching Blocks to Dimplex Header

Page 3

1 1/4"

 

Screw

Long Wood

 

 

Block

Short Wood

 

Block

 

Dimplex

 

Header

 

Figure 5 - Attaching Blocks to Dimplex Header

1 1/4" Screw

Mantel

 

Header

Long Wood

Block

3.Attach supplemental brackets using 1/2" or 3/4" screws provided in bracket hardware kit. Use 3 brackets to attach top to mantel assembly - one at back of each leg assembly and one at center of header (see Figure 8).

4.Place mantel base next to wall at installation location. See fireplace owner's manual for installation clearances.

5.Place mantel assembly onto mantel base and center left to right with the back flush with the back of the base (see Figure 9).

6.Use 1 1/4" screws in pocket holes to attach mantel assem- bly to mantel base. Using brackets and 1/2" - 3/4" screws from bracket hardware kit, attach support brackets to base and mantel assembly - one at each back corner of the leg sides and one on each leg front (see Figure 9).

Small Gap Between

Header and Top

Short Wood

Block

Dimplex

Kit Header

Make certain

 

spacing is

 

the same

Bracket

front and

1/2" or 3/4"

back.

 

Screw

Legs Should Be Flush With Top

1 1/4"

Screws

Figure 6 - Mantel Kit Installation for Dimplex

Attaching Top of Mantel

1.Place top onto mantel (see Figure 7). The rear of legs should be flush with back of mantel top and centered left to right (see Figure 7).

2.Make sure mantel is centered left to right inside top and rear of legs are flush with back of top. Gap between mantel top and leg should be the same from front to back (see Figure 8). Use 1 1/4" screws through pocket holes in the side assemblies and the front to attach top of mantel.

Mantel

Top

Header

Leg

Assembly

Figure 7 - Placing Mantel Top Onto Mantel Assembly

Figure 8 - Attaching Mantel Top to Leg and Header Assembly

1 1/4" Screws

1/2" or 3/4" Screw

Bracket

Mantel Base

Figure 9 - Attaching Mantel Assembly to Mantel Base

119939-01A

www.desatech.com

Image 3
Contents Wall Mantel and Base with Trim Assembly and Installation InstructionsAssembling Mantel For installation with dimplex electric fireplace onlyAttaching Blocks to Dimplex Header Attaching Top of MantelInstalling FireplacE Assembling metal Trim Included with Gas FireplaceClose louver door Instrucciones DE Ensamble E Instalación Repisa de pared y base con adornoEnsamble de la repisa para chimenea Para instalación en chimeneas eléctricas Dimplex únicamenteColoque cuidadosamente la repisa en posición vertical Cómo fijar la parte superior de la repisa para chimenea Ensamble del adorno de metal incluido con la chimenea a gas Instalación de la chimeneaRetire el embalaje de las tres piezas del adorno metálico