FIREPLACE INSTALLATION
Installing Logs, Lava Rock, and Glowing Embers
23
FIREPLACE INSTALLATION
Continued
2.Rest left side of log #2 (front log) onto top of log #1. Place right side of log onto second pin located on right side of grate (see Figure 41).
3.Place log #3 (rear log) onto pins on rear of grate as shown in Figure 42.
4.Place log #4 (crossover log) onto pins from both logs #2 and #3 as shown in Figure 43.
5.Place log #5 (top log) onto right pin of front log (#2) and the smooth surface of crossover log (#4) as shown in Figure 44. Make sure it is seated properly.
6.Place log #6 (left log) onto left pin of front log (#2) and the smooth surface of rear log (#3) as shown in Figure 45. Make sure it is seated properly.
7.Place log #7 onto right pin of top log (#5) as shown in Figure 45. Make sure it is seated properly
8.Place lava rock along sides and front of firebox bottom in ar- eas that are visible only. It is not necessary to use all of the lava rock provided.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause perfor- mance problems.
2
Figure 41- Installing Log No. 2
3 | 4 |
|
9.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto the ex- posed section of the front burner and along the space between the burner and grate prongs (see Figure 46). This will create the glowing ember appearance as the flame touches the ember material. Do not block air slots by using too much ember ma- terial in one area. It is not necessary to use all of the ember material provided.
10.Close glass door, lock door latches, replace screen, and close louvers (see Removing/Replacing Glass Door, steps 5 through 7, page 21).
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
5
Figure 44 - Installing Log No. 5
6 | 7 |
|
Figure 45 - Installing Log No. 6 and Log No. 7
Figure 42 - Installing Log No. 3 Figure 43 - Installing Log No. 4
Ember Material
Figure 46 - Placing Ember Material on Burner
For more
visit www.
.com
