TROUBLESHOOTING
27
TROUBLESHOOTING
Continued
WARNING: If you smell gas
•Shut off gas supply.
•Do not try to light any appliance.
•Do not touch any electrical switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
OBSERVED PROBLEM | POSSIBLE CAUSE | REMEDY | ||
|
|
|
|
|
Fireplace produces a clicking/ticking noise | 1. | Metal expanding while heating or con- | 1. | This is common with most fireplaces. |
just after burner is lit or shut off |
| tracting while cooling |
| If noise is excessive, contact qualified |
|
|
|
| service person |
|
|
|
|
|
Slight smoke or odor during initial | 1. | Residues from manufacturing processes | 1. | Problem will stop after a few hours of |
operation |
| and logs curing |
| operation |
|
|
|
|
|
Gas odor even when control knob is in OFF | 1. | Gas leak. See Warning statement at | 1. | Locate and correct all leaks (see Check- |
position |
| top of page |
| ing Gas Connections, page 19) |
| 2. | Control valve defective | 2. | Replace control valve |
|
|
|
|
|
Gas odor during combustion | 1. | Foreign matter between control valve | 1. | Take apart gas tubing and remove for- |
|
| and burner |
| eign matter |
| 2. | Gas leak. See Warning statement at | 2. | Locate and correct all leaks (see Check- |
|
| top of page |
| ing Gas Connections, page 19) |
|
|
|
|
|
Glass soots | 1. | Debris around burner air mixer | 1. | Inspect the opening at the base of the |
|
|
|
| burner by removing log/grate assem- |
|
|
|
| bly to see that it is NOT packed with |
|
|
|
| any type of material [see Installing |
|
|
|
| Brick Liner Models BL36DA(SA) and |
|
|
|
| BL36DHA(SA)] for log/grate removal |
| 2. | Improper vent configuration | 2. | Check vent configuration specifications |
|
|
|
| (see Venting Installation Instructions, |
|
|
|
| page 7) |
|
|
|
|
|
Dark residue on logs or inside of fireplace | 1. | Air holes at burner inlet blocked | 1. | Clean out air holes at burner inlets. Pe- |
|
|
|
| riodically repeat as needed |
| 2. | Burner flame holes blocked | 2. | Remove blockage |
| 3. | Improper venting or excessive blockage | 3. | Have the vent system inspected, includ- |
|
|
|
| ing the termination cap. Remove any |
|
|
|
| restrictions or obstruction |
| 4. | Excessive amounts of embers and pan | 4. | Clear excess embers until a minimum |
|
| material |
| gap of 1/2" remains under the grate |
www.desatech.com |