Desa MSVFBNR Series installation manual Operating Heater, For Your Safety Read Before Lighting

Page 14

SUN VALLEY STOVE COMPANY

VENT-FREE NATURAL GAS STOVE HEATER

OPERATING

HEATER

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been un- der water.

AUTO

OFF

ON

LIGHTING

INSTRUCTIONS

MSVFBNR REMOTE-READY MODELS

NOTICE: During initial operation of new heater, burning logs will give off a paper-burning smell. Open window to vent smell. This will only last a few hours.

1.STOP! Read the safety information, column 1.

2.Make sure equipment shutoff valve is fully open.

3.Set switch to OFF position.

WARNING: Burners will come on automatically within one minute when the selector switch is in the ON position after the pilot is lit.

4.Press in and turn control knob clock-

wise to the OFF position.

5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety in- formation column 1. If you don’t smell gas, go to the next step.

6.Press in and turn control knob coun-

terclockwise to the PILOT position. Press in control knob for five (5) seconds (see Figure 25).

Note: You may be running this heater for the first time after hook- ing up to gas supply. If so, the con- trol knob may need to be pressed in for 30 seconds or more. This will al- low air to bleed from the gas system.

Flame Adjustment Knob

Control Knob

IH

 

O

 

F

N

F

O

P

LO

LI

TO

7.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep press- ing ignitor button until pilot lights.

Note: If pilot does not stay lit, con- tact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Light- ing Procedure on page 15.

8.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs.

Note: If pilot goes out, repeat steps 4 through 8.

9.Slightly push in and turn control

knob counterclockwise to the ON position.

10.Wait one minute and switch selector switch to the ON position to light burners. Note: AUTO is only func- tional when using GWMT1 or GWMS2 optional accessories.

11.Set flame adjustment knob to any level between HI and LO.

CAUTION: Do not try to adjust heating levels by using the equip- ment shutoff valve.

WARNING: Make sure the selector switch is in the OFF po- sition when you are away from home for long periods of time. Heater will come on automati- cally with selector switch in the ON position.

Pilot Burner

Ignitor Electrode

Ignitor Button Selector Switch in OFF Position

Figure 26 - Pilot

Figure 25 - Control Knob and Ignitor Button Location (Shown as Supplied,

 

No Control Options)

 

For more information, visit www.desatech.com

14

105985

Page 13 Page 15
Image 14
Page 13 Page 15
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASSafety Information SUN Valley Stove CompanyLocal Codes Product FeaturesProduct Identification Unusually Tight Construction AIR for Combustion and VentilationProviding Adequate Ventilation Confined and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space AIR for Combustion VentilationDetermining FRESH-AIR Flow for Heater Location Building Ventilation AIRVentilation Air From Inside Ventilation Air From OutdoorsClearances to Combustibles InstallationCheck GAS Type Vent-Free Operation OnlyStove Cavity Assembly Lift off corrugated box enclosing stove body cratingAttaching Stove Legs Installing GAS LOG Heater Into Stove Fastening Heater Base to Stove Drop BottomConnecting to GAS Supply Installation Items NeededChecking GAS Connections Pressure Testing Heater Gas ConnectionsPressure Testing Gas Supply Piping System Installing Optional Wall Mounted Thermostat GWMT1 Installing Optional Wireless HAND-HELD Remote ControlLighting Instructions Msvfbnr REMOTE-READY Models For Your Safety Read Before LightingOperating Heater Optional Remote Operation Manual Lighting ProcedureTo Turn OFF GAS To Appliance Lighting Instructions Msvfbn Manual VARIABLE-CONTROL Models Variable Control OperationBurner Primary AIR Holes Inspecting BurnersPilot Flame Pattern Main BurnerLogs Cleaning and MaintenanceCleaning Burner Injector Holder and Pilot AIR Inlet Hole Transporting StoveTroubleshooting Observed Problem Possible CauseObserved Problem Possible Cause Remedy Top Wiring Diagram Specifications Service Hints Replacement PartsTechnical Service Parts Under WarrantyAccessories Illustrated Parts Breakdown MsvfbnrParts List KEY Part Number Description QTYMsvfbn KEY Part Description QTY SUN Valley Stove SUN Valley Stove MC* Series Indicates Color Suffix DesignationSUN Valley Stove Mchp Series Hepplewhite Stove Design SUN Valley Stove Mchp Series Hepplewhite Stove DesignWarranty Information International

MSVFBNR Series specifications

The Desa MSVFBNR Series is a remarkable innovation in the realm of heating solutions, designed to cater to the diverse needs of both residential and commercial spaces. Built with the latest technology and user-centric features, the MSVFBNR Series stands out as a leading choice for individuals seeking efficient, reliable, and stylish heating options.

One of the standout features of the MSVFBNR Series is its Energy Star rating, which emphasizes its energy efficiency and environmentally friendly operation. By utilizing advanced combustion technologies, these units optimize fuel usage, reducing energy consumption and lowering utility bills. This eco-conscious design not only benefits the wallet but also contributes to a more sustainable future, making it an appealing choice for environmentally conscious consumers.

The MSVFBNR Series integrates state-of-the-art safety technologies to ensure peace of mind for users. With built-in safety shutoff mechanisms and automatic ignition systems, these heaters prioritize user safety. The incorporation of a thermal protection feature prevents overheating, providing a secure heating solution for families and businesses alike.

Ease of use is another hallmark of the MSVFBNR Series. The user interface is designed to be intuitive, allowing for seamless operation and customization. With programmable thermostats and remote control capabilities, users can easily adjust the heating schedule to suit their lifestyles. This adaptability not only enhances comfort but also promotes energy savings.

Durability is a key characteristic of the MSVFBNR Series, with robust construction materials designed to withstand the rigors of daily usage. The series features a sleek, modern design that seamlessly integrates into a variety of décor styles, making it a versatile addition to any space.

Finally, the MSVFBNR Series is available in a range of models and sizes, ensuring that there is a perfect fit for every application. Whether you need supplementary heat for a single room or a primary heating source for a larger space, the MSVFBNR Series offers tailored solutions to meet your requirements.

In conclusion, the Desa MSVFBNR Series combines cutting-edge technology, user-focused features, safety, and style, making it an ideal choice for those in search of a dependable heating solution. Its energy efficiency, ease of use, and durable construction solidify its position as a leader in the heating industry.
Top Page Image Contents