14 Operating
With wired connection
| 1. | Connect your LG TV to the unit by using an |
|
| optical cable. (Refer to the pages 10 - 11.) |
| 2. | Set up LG Sound Sync (Optical) on the TV. Refer |
|
| to the TV's instruction manual. |
| 3. | Turn on the unit by pressing 1 (Power) on the |
|
| remote control. |
| 4. | Select OPTICAL function by using OPTICAL on |
2 |
| the remote control. |
Operating |
| Green LED on the unit is lit up for about 3 |
| seconds and you can listen to the TV's sound. | |
|
| |
| With wireless connection | |
| 1. | Turn on the unit by pressing 1 (Power) on the |
|
| remote control. |
| 2. | Select LG TV function by using LG TV on the |
|
| remote control. Then white LED on the unit |
|
| starts to blink. |
| 3. | Set up LG Sound Sync (Wireless) on the TV. Refer |
|
| to the TV's instruction manual. |
When connection is completed normally between this unit and your TV, white LED on the unit is lit up for about 3 seconds. ,,Note
If you turned off the unit directly by pressing 1 (Power), LG Sound Sync (Wireless) will be disconnected. To use this function again, you should reconnect the TV and the unit.
AUTO POWER On/Off
This function automatically turns on/off the unit when you turn on/off the TV or the external device (DVD Player,
It is supported only on OPTICAL and LG TV functions.
You can turn on or off AUTO POWER function by using AUTO POWER ON/OFF switch on the rear panel of the unit.
,,Note
yy After the unit is turned on by AUTO POWER function, it will be automatically turned off if there is no signal for a certain period of time from the TV connected by LG Sound Sync (Optical/Wireless).
yy After the unit is turned on by AUTO POWER function, it will be automatically turned off if there is no signal for a certain period of time from the external device connected by an optical cable.
yy AUTO POWER function is initially turned on.
yy If you turned off the unit directly, it cannot be turned on automatically by AUTO POWER function. However the unit can be turned on by AUTO POWER function when optical signal comes in after 5 seconds of no signal.
yy Depending on the connected device, this function may not operate.
yy When booting this unit on LG TV fucntion, it takes about 25 seconds to turn it on and the red LED is blinking twice per second.
During that time, you cannot control this unit except turn it off.
yy In Bluetooth mode, this unit may be turned on by AUTO POWER setting depending on the connected Bluetooth device and then LG TV function is selected.
In this case the unit will be turned off automatically and when you restart the unit, it will be turned on by LG TV function.