Vermont Casting BFC36 Finish Glass Doors, Glass Door Operation, Installing Line for Gas Logs

making sure the flat side of the threaded shaft is fac- ing up and handle stub is pointing down. (Fig. 25)

FP1594

Fig. 25 Right handle stub in place.

6.Remove small locking nut from left door handle stub shaft.

7.Insert handle shaft through handle opening in left door. Secure with small locking nut.

8.Close the left door. To close the right door, turn the right handle stub to the right and up. Close the door and turn the handle stub to the left and down to secure door. (Fig. 26)

Left Handle is	Turn Counter-
Stationary
	clockwise to
	Open

FP1596

Fig. 26 Turn right door handle counterclockwise to open.

Finish Glass Doors

The fallaway handles are used to open and close the front doors. The fallaway handles may be removed after each use or may be left in place. CAUTION: If the handles are left in place during operation, they may become hot. (Fig. 27)

Adjust door alignment by loosening the phillips head screws which secure the door hinges to the door. Adjusting one hinge while leaving the other tight will serve to rotate the inner edge up or down. Adjusting both hinges at the same time allows the door to adjust side-to-side.

BFC36 Balance Flue Heat-Circulating Fireplace

Steel Handle

Fallaway

Handle

FP1584

Fig. 27 Insert fallaway handle into steel handle.

Glass Door Operation

The BFC36 is intended for use only with the doors fully closed. (Fig. 28)

	Correct	Wrong
		KT108b
Fig. 28	Correct door position.

Glass Door Operation

The BFC36 is intended for use only with the doors fully closed. (Fig. 28)

Installing Line for Gas Logs

CFM Corporation fireplaces are designed to accept a 1/2” (13mm) gas line for installation of an approved gas appliance. (CFM Corporation manufactures a wide va- riety of gas logs for use in CFM Corporation fireplaces.)

Be sure to have the appliance installed in accordance with building codes.

Gas connection may enter from either left or right side of the fireplace.

Locate appropriate gas line in the outer casing of fire- place and remove insulation from gas line tube. (Fig. 29)

From inside the fireplace, locate the knockout on the firebrick -- be sure you are on the appropriate or “gas line” side of the fireplace. Using a flat bladed screw- driver or small chisel and hammer, carefully tap around the knockout until it loosens and falls out.

7412647 17