CHDV37N/P AND CHDV41N/P
DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)
FIREPLACE INSTALLATION
Continued
INSTALLING LOGS, LAVA ROCK AND GLOWING EMBERS
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with fireplace.
Remove glass door. See Removing/Replacing Glass Door, page 22. Install logs according to instructions for fireplace model numbers.
Fireplace Models CHDV37N/P and CHDV41N/P
1.Place log #1 (back log) on grate. Make sure the lower middle section of the log fits securely into the open area in back of grate (see Figure 49).
2.Place log #2 (two log assembly) onto pins on left and right of the front burner (see Figure 50). The middle pin is not used.
3.Place log #3 (crossover assembly) onto the notched out section of log #2. Log #3 rests on the back portion of front log and in the crook of back log (see Fig- ure 51).
4.Place lava rock along sides and front of firebox bottom.
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner could cause performance problems.
It is not necessary to use all of the lava rock provided.
5.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely onto the exposed section of the front burner and space between logs 2 and 3 where front burner is exposed (see Figure 52). This will create the glowing appearance as the flame touches the em- ber material. Do not block ports by us- ing too much ember material in one area. It is not necessary to use all of the em- ber material provided.
6.Replace the glass door. See Removing/ Replacing Glass Door, page 22.
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
1
Figure 49 - Installing Log No. 1
2
3
Figure 51 - Installing Log Assembly No. 3
Ember Material
Figure 52 - Placing Ember Material on Burner
Figure 50 - Installing Log Assembly No. 2
24 | 104605 |