Operation
Electric Fireplace Manual Controls
The manual controls for the fireplace are located in the lower right hand corner (Figure 3).
A.Main On/Off Switch Supplies power to the 3 position manual control switch.
B.3 Position Manual Control Switch
Remote (right position): The unit is operated with the remote control.
Flame (center position): The flame effect is turned ON.
Flame & Heat (left position):
The flame effect and heater are turned ON simultaneously. When the manual control is in the Flame & Heat position the heater does not run on the remote operated thermostat.
C.Initialization Button
Used to synchronize remote control.
!NOTE: When the manual control switch is in the Flame and Flame & Heat positions, the fireplace unit will not operate with the remote control.
Figure 3 |
|
|
A | B | C |
Resetting The
Temperature Cutoff
Switch
The heater is protected with a safety device to prevent overheating. Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It can be reset by switching the ON/OFF Switch to OFF and waiting five (5) minutes before switching the unit back on.
CAUTION: If you need to continuously reset the heater, unplug the unit and call Dimplex North America Limited at
10 | www.dimplex.com |