Fireplace Installation
Figure 1 |
| |
31 ⅜" (797 mm) | 10 ½" | |
30 ¼" (768 mm) | ||
(267 mm) | ||
| 26 ⅜" | |
| (670 | |
25 ½" | mm) | |
(648 |
| |
mm) |
|
For dimensions of the firebox insert, with and without the trim, refer to Figure 1. The fireplace does not require any additional venting.
!NOTE 1: A 15 Amp, 120 Volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
Install the fireplace assembly into the mantel (refer to mantel assembly instructions).
!IMPORTANT: If not using a
Dimplex mantel, the firebox must be installed in an enclosure with the following MINIMUM internal/opening dimensions (Figure 2).
New Wall Construction
1.Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic.
2.Place the fireplace in the desired location to see how it will look in the room.
8 | www.dimplex.com |