Dimplex DF2603 ·To open the light bulb area, Helpful Hints, Backledge LOG, Rear TAB Sidesection

GLASS

COUCH

FIGURE￿11

An￿example￿of￿a￿safe￿storage￿place

BACK￿LEDGE	LOG
	EMBERBED

REAR TAB

SIDE￿SECTION

·To open the light bulb area:

1.Remove trim by pulling straight forward.

2.Hold glass in place while removing retaining clip as shown in FIGURE 10 (a,b,c).

3.Lift glass out and store in a safe place FIGURE 11.

CAUTION

·Even though the glass is safety glass it may break if bumped, struck or dropped. Care must be taken when handling the glass.

Helpful Hints

It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace fight bulbs.

·To replace the bottom light bulbs which generate the flames and embers:

Bulb Requirements: Quantity of 4 clear chandelier or candelabra bulbs with an E-12 (small) socket base, 60 watt rating, Example GE 60BC or Phillips 60CTC.

CAUTION

·Do not exceed 60 watts per bulb

LIFTING￿OUT LOG

EMBERBED

FIGURE￿12

1.Lift up front edge of log until clears the front tabs. Pull out until the rear tab clears the back ledge, then lift out. (FIGURE 12)

2.Examine the bulbs to determine which bulbs require replacement.

3.Hold the socket while unscrewing the bulb. (FIGURE 13)

4.Hold the socket while screwing in the new bulb.

5.Replace the log by pushing it down and in until it rests against the mirror. (FIGURE 12)

7

FIGURE 13