Dimplex Electric Fireplace manual Mirror Cleaning, To access the light bulb area

FIGURE 4

FIGURE 5

To access the light bulb area:

1.Open steel curtain (remove glass doors if applicable).

2.Remove two screws on log grate and remove log grate (FIGURE 4).

3.Pull rear edge of ember bed up and forward by grasping ember bed by the sides (handle the logset only by the emberbed and not the logs) and pulling solidly until the rear tab pops out from under the back ledge, then lift out. (FIGURE 5)

4.Examine the bulbs to determine which bulbs require replacement.

5.Unscrew bulbs counter clockwise.

6.Insert new bulbs.

7.Replace the log by inserting front edge and pushing the back down until rear tab snaps under back ledge (FIGURE 5) and the logs are resting against mirror.

8.Replace log grate using two screws previously removed.

Mirror Cleaning:

The mirror is cleaned in the factory during the assembly operation. During shipment, installation, handling, etc., the mirror surface may collect dust particles; these can be removed by buffing lightly with a clean dry cloth.

To remove fingerprints or other marks, the mirror can be cleaned with a damp cloth using good quality household glass cleaner. The mirror should be completely dried with a lint free cloth or paper towel.

CAUTION

•Do not use abrasive cleaners on mirror surface or spray liquids directly onto any surface.

6