Model / MOD Specific Procedures
Light Bulb Replacement
Allow at least five (5) minutes for light bulbs to cool before touching bulbs to avoid accidental burning of skin.
Light bulbs need to be replaced when you notice a dark section of the flame. There are two (2) bulbs under the log set which generate the flames and embers.
Disconnect power before attempting any maintenance or cleaning to reduce the risk of electric shock or damage to persons.
Helpful Hints
It is a good idea to replace all light bulbs at one time if they are close to the end of their rated life. Group replacement will reduce the number of times you need to open the unit to replace light bulbs.
Light Bulb Requirements
Quantity of two (2) clear chandelier or candelabra bulbs with an
Do not exceed 60 Watts per bulb
Replacement Procedure for:
DFI2309 & DFI2310 MODs ~ to C
1.Remove the two (2) outer Phillips screws on the log grate at the front of the firebox as shown in Figure 11.
Figure 11 |
Log Set |
Screws to |
remove (2) |
Flame |
assembly drawer |
2.Pull the flame assembly drawer out approximately 1½ inches (4 cm), or until it stops.
3.Carefully remove the Log Set from the firebox.
4.Disconnect LED harness to Log Set (DFI2310 only). Set Log Set aside (Figure 12).
5.Pull Flicker Rod to the far right, towards the Flicker Motor,
Figure 12 |
Flicker Rod |
Bulbs (2) |
LED wire harness |
carefully bend the Flicker Rod enough to release the opposite end from the mounting bracket (Figure 12).
6.Pull Flicker Rod off of the shaft of the Flicker Motor and set aside.
7.Remove bulb(s) by turning
8.Push rubber grommet of Flicker Rod back onto shaft of Flicker Motor and carefully bend Flicker Rod so as to insert opposite end back into mounting bracket.
!NOTE: If Flicker Rod is bent out of alignment, carefully bend it back to become straight. If Flicker Rod is not properly aligned, it may cause noise during operation by rubbing against metal chassis.
9.Follow steps 1 through 4 in reverse order to reassemble firebox.
Replacement Procedure for:
DFI2309 & DFI2310 MODs ~ to C
1.Remove the four (4) Phillips screws on the log grate at the front of the firebox as shown in Figure 13.
Figure 13 |
|
|
Log Set |
|
|
Flicker Rod |
|
|
Screws to remove (4) |
| LED wire |
Bulbs (2) | harness | |
|
|
14