Other Functions

Sleep Timer Setup

You can set up the DVD/CD receiver to turn off auto- matically at a specified time.

1Press SLEEP to set up a sleep time.

The SLEEP indicator and sleep time appears in the dis- play window.

2Each time you press SLEEP the setting changes in the following order.

SLEEP 90 →80 → 70 → 60→ 50 → 40 → 30 → 20 →10 →

OFF

ote

You can check the time remaining before the DVD/CD receiver turns off.

Press SLEEP. The remaining time appears in the display window.

Dimmer

This function changes the brightness of the display win- dow on the front panel during power-on status.

Press DIMMER repeatedly.

Mute

Press MUTE to remove the sound.

You can mute your unit in order, for example, to answer the telephone, “MUTE” indicator flashes in the display window.

Press MUTE again to restore the sound.

Using Headphones

Connect a stereo headphone plug (3.5mm) into the PHONES input jack.

The speakers are automatically disconnected when you plug in a headphone (not supplied).

Selecting Input Sources

You can use a VCR or other devices connected to the VIDEO1, VIDEO2 jacks or the Optical input. Refer to the owner’s manual supplied with the device(s) for further information on their operation.

Press AUX repeatedly on the remote control to select the desired input source.

Each time you press this button, the sources change in the following sequence:

VIDEO 1: for selecting the analog signal from VIDEO1 AUDIO IN (L/R) & VIDEO IN jacks.

VIDEO 1 OPT: for selecting the digital signal from VIDEO 1 OPTICAL IN jack.

VIDEO 2: for selecting the analog signal from VIDEO2 AUDIO IN (L/R) & VIDEO IN jacks.

VIDEO2 OPT: for selecting the digital signal from VIDEO 2 OPTICAL IN jack.

otes

The Optical input function is available only when the other unit’s Sampling Frequency is 32 ~ 96kHz. You can also select the input source with the PLAY/FUNCTION button on the front panel.

Press and hold down this button about 3 seconds, then press repeatedly to select other input source.

OPERATION