Weber 42376 manual Check for GAS Leaks, To Connect the hose to the cylinder

Page 10

10

GAS INSTRUCTIONS

 

 

To Connect the hose to the cylinder:

3)Remove the plastic dust cover from the valve.

4)Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only.

Note: This connection tightens clockwise and will not allow gas to flow unless

the connection is tight. The connection requires tightening by hand only.

WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.

5)Mix soap and water.

6)Turn on the cylinder valve.

7)Check for leaks by wetting the fi tting with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.

If there is a leak, turn off the gas and tighten the fi tting. Turn the gas back

on and recheck with the soap and water solution.

If leak does not stop, contact the Summit® Built-In Customer Service at 1-800-446-1071. Do not use the barbecue.

8)When leak checking is complete, turn gas supply OFF at the source and rinse connections with water.

CHECK FOR GAS LEAKS

After a period of nonuse, we recommend that you perform the following

maintenance procedures for your safety.

WARNING: Check the hose before each use of the grill for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the grill. Replace using only Summit® authorized replacement hose. Contact the Summit® Built-In Customer Service at 1-800-446-1071.

•Inspect the burner for correct fl ame pattern. Clean if necessary, following the procedures outlined in the “General Maintenance” section of this manual.

•Check all gas fi ttings for leaks.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber Gas Barbe- cue. Shipping and handling may loosen or damage a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it. Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Make sure side burner is OFF.

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

WARNING: Do not ignite burners when leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

Check:

1)Corregated gas line-to-Accessory “T” Connection

2)Regulator-to-Cylinder connection.

WARNING: If there is a leak at connection (1), retighten the fitting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after re-tightening the fitting, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact Customer Service 1-800-446-1071.

Page 9 Page 11
Image 10
Page 9 Page 11
Contents BUILT-IN LP Side Burner INSTALLATION/OWNERS Guide SummitLiquid Propane GAS Units only Warranty WARRANTY3Operating Storage AND/OR Nonuse GAS Instructions All dimensions are to fi nished surfacesLocating Your BUILT-IN Side Burner Test Connections BUILT-IN GAS Line Locations General Construction DetailsMounting the Side Burner GAS Line Piping Typical Bulk Propane GAS Supply InstallationSize Inches 100 125 150 175 200 Typical 20 LP Propane GAS Supply Installation Back of box Connect GAS SupplyTop of box Side ViewImproper Filling is Dangerous Test Connections Connecting the Liquid Propane CylinderFill Liquid Propane Cylinder Important LP Cylinder InformationCheck for GAS Leaks To Connect the hose to the cylinderOPERATING11 Always close the cylinder valve before disconnectingSafe Handling Tips for Liquid Propane GAS Cylinders Side Burner Lighting Instructions 12OPERATINGLiquid Propane LP Cylinders Lighting the Side BurnerCrossover Ignition System Operations MAINTENANCE13Manually Lighting the Side Burner Replace Igniter BatteriesSide Burner Maintenance Side Burner TroubleshootingProblem Check Cure Side Burner does not lightPage WEBER-STEPHEN Products CO
Related manuals
Manual 16 pages 58.05 Kb

42376 specifications

The Weber 42376 is a versatile and innovative grill that caters to both seasoned chefs and grilling novices. This model stands out in the realm of outdoor cooking equipment due to its thoughtful design, remarkable features, and cutting-edge technologies that enhance the overall grilling experience.

One of the main features of the Weber 42376 is its powerful performance. It is equipped with a robust cooking system that delivers even heat distribution, allowing for perfect cooking results every time. The grill offers a spacious cooking area, providing ample room for preparing multiple dishes simultaneously. Additionally, the durable cooking grates are designed to retain heat, ensuring that your meats sear beautifully while locking in flavor and moisture.

Furthermore, the Weber 42376 incorporates advanced technologies to streamline the grilling process. One such feature is the integrated Flavorizer Bars, which are strategically placed to catch drippings and create smoke, adding a delicious, smoky flavor to your food. This innovative element not only enhances the taste but also reduces flare-ups, providing a safer grilling experience.

Another highlight of the Weber 42376 is its easy-to-use ignition system. The electronic ignition feature ensures that starting the grill is quick and hassle-free, allowing you to get cooking without delay. The model also boasts a built-in thermometer that provides accurate temperature readings, enabling you to monitor your cooking without lifting the lid.

The construction of the Weber 42376 is designed for longevity and resilience. With a combination of high-quality materials, such as stainless steel and porcelain-enameled components, this grill is built to withstand the elements and resist rust and corrosion. This not only ensures a longer lifespan but also makes it easier to maintain and clean.

In terms of portability, the Weber 42376 is designed with convenience in mind. It features sturdy wheels that allow for easy movement, enabling you to relocate your grill effortlessly in your backyard or patio. This makes it ideal for those who love outdoor gatherings, tailgating, or camping.

Overall, the Weber 42376 is a premium grill that offers a delightful blend of performance, technology, and durability. Whether you are hosting a barbeque party or enjoying a quiet evening meal, this grill is sure to elevate your culinary experiences and bring the joy of outdoor cooking to your home.
Top Page Image Contents